My Kenmore HE2t will not rinse all of the water out of the rinse cycle then automatically shuts itself off before the spin cycle. Any suggestions?

Hi Jim, I'm assuming that is a front loader, is that correct?. please give the full model#.

so you have the same problem I had. mine had a quarter stuck in the drain line. I had to remove the front cover and find the drian hose and mad a huge mess pulling the hose off. have a shop vac and be ready to suck up a lot of water when you pull the clamps lose. once you get the water out then you can inspect the hose and any parts that could be bad. there is only a couple things it could be. clogged; broken pump; or a bad signal from the computer to turn the pump on.

You may have a faulty water level switch which is shutting off the water sooner than it should. it may also be a faulty pc board

htc sensor isnt working i would recon
perhaps the element isnt getting power
did it trip your circuit breaker
some times the htc fails
all you get is machine stop because the heater is not detected

if it spins rinses and empties in a timely manner
then all thats left is the heater system

try looking at your pump or you need a cupler that goes on the back sid of the motor price range for the pump is 120 dollars and the cupler is 35 dollars dont quote me on the price of the parts please but that should fix the problem.

The cycle doesn't advance When the cycle doesn't advance, it's probably the timer or a cold-water supply problem: It's the timer, if your washing machine fills with water and begins agitating, but the timer never advances--or if the washer is in a spin cycle and the timer won't advance. Then you need to replace the timer. It may be a cold-water supply problem, if the washing machine fills with water, agitates, drains, and spins, but then doesn't fill with rinse water. See There's no cold water.

Drain hose must be at least 30 inchs above the floor.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

door switch bad?

Hi this could means that you may need to replace the washing machine bearings. Once the bearings are bad, the motor overheats and it will automatically shut down after the first rinse.

Timonty from WashingMachineAdvisor.com

where is the lint trap located