Type of cable from wall cable outlet to tv plus what imput to use Thanks

TV is showing cameras, maybe you forgot to set the hdmi imput on other tv, each html socket is an imput on tv I had.

Use HDMI wire if you have that option than simply tune TV to HDMI 1 or HDMI 2 etc depending which one you connect it to .
OR. analog ( R C A ) cables analog. Output from DVD player to imput tv """ red is right white. Is left sound. Yellow is video pay attention to where you are plugging on TV.video 1 or 2 or 3 Since you will have to go to ( video. Or imput ) on your TV to access the DVD player. Another words your cable box is a TV imput . You're doing is also a TV imput You have to tune it to be able to watch it

Unfortunately Without the cable box you will have to screw the coax cable into the coax input on the tv or You can screw the coax cable into a vcr and then plug the Audio / Video RCA plugs from VCR out to TV RCA input (You will have to control the channels from the VCR and the volume from the TV remote)

look on the internet for a hub like usb ones the computers use.

it should be set on channel imput 1 or imput 2.

turn off your cable box
turn off the dvr
disconnect cable box from wall outlet
disconnect dvr from wall outlet
unplug e-sata cable from dvr
replug e-sata cable back in to dvr
plug dvr into wall outlet
turn on dvr
plug in cable box to wall outlet
turn on cable box
wait for cable box to go completely thru startup procedure
...then try your list button again.

Is the TV connected directly to the outlet in the wall or through a power outlet on the cable box? If so connect the TV directly to the wall and see at least if it does power up. If it does than the cable box is bad and will need to be replaced. If neither the cable box or TV power up when connected directly to the outlet then the possibility is you had a power surge that damaged both.

Check wall outlet for current if it dont come on, go to anoter outlet, if the unti fails to turn on its a power supply unit fuse inside deeds to be replaced thanks

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/edwy_1a56970cf1ea4620

Reset the cable/sat box and tv by turning them off, unplugging them both from the wall outlet, and replugging them after 30 seconds. See if you get pictue back when they get the correct handshake. also, make sure that there are no loose cables going into the TV or into the cable/sat box. You can try using a different type of connecting cord from the cable/sat box to the tv to make sure it is not a bad connecting cord.

What type of cable is connecting your cable/sat box to the TV? Is it HDMI?

Are you using a video game system on the plasma?

if you scan down below channel 2 doesn't video show up? otherwise there should be a input / video button