The samsung monitor ssc21web shows system initialize... the three periods blink

Have you tried unplugging the monitor from the 120 volt supply for a minute or two then replug and turn on. Like computers and some flat panel TVs they can freeze-up after an unplanned power loss and need rebooting

Hi, the tire pressure monitor detects any changes in the tire inflation pressure. Therefore, it must initialize and store it in its memory if the tires or wheels have been replaced, re-inflated or the tires have been rotated. You can re-initialize the system by following these steps:

1. Check and make sure that your tires are inflated to the correct pressure

2. Turn the ignition switch to the ON position. If the low tire pressure warning light comes on, push and hold the tire pressure warning reset switch (in the glove box) until the warning light turns off and then release the switch.

3. Now press and hold the tire pressure warning reset switch until the low tire pressure warning light blinks three times.

4. Initialization is *not* completed until driving at the vehicle speed of 19 mph or over for more than one hour. the tire pressure monitoring starts when initialization is completed.

Sounds like your camera has switched over to storing pictures on the internal memory which is very small. With the card out of the camera, go into the menu and find "format"...follow the on-screen instructions to erase the internal memory. Then, using a separate card reader, download any pics from the memory card. Then, insert the card back into the camera and do the "format" thing again to erase and initialize the card. Everything should be back to normal. By the way, your camera can't get a virus.

I would advise possibly getting a quad to view all 4 cameras. You can also check on the back of the DVR if there is any other place to plug your monitor into. Usually there is a spot port and a monitor port. One will give you the split screen without using a quad. Any camera should work on your system. You would just need to buy a prefabricated cable if you are not familiar with termating BNC connectors. I have a site below that was helpful when installing the cameras at my house. Hope this was helpful.

http://www.123securityproducts.com/

is this poe cam? cable footage over 300 ft needs cat5 extender if fiber check media converter to see if single or multimode also check media converter for tx/rx or using cat5 b crossover cable connect directly to laptop type in ip in command bar enter

Samsung told me the newer versions of Windows and Internet Explorer, will not work with this system. Microsoft told Samsung it was their problem. Find a old computer with ME and Explorer 5 and it will work again. I have the ssc17web.

It's a quad. It records all 4 cameras at the same time. You can display 1 cam at a time. If you play it back, you have to hit the buttong that displays the corresponding camera you want to review.

Have you setup a Virtual Server within the D-Link router? This should be on the ADVANCED tab in the D-Links Admin Configuration interface. Upon setup, the router should allow pass through of your request to the network connected device.

You will need the following in this configuration:

Name of device: SSC21WEB (or whatever the name of your device is)
IP Address: 192.168.0.101
Protocol Type: TCP
Public/Private Port: 10000 - 65535
Schedule: Always

Good Luck...

1. check connection wires and terminals are connected correctly there is no struggle in the cable or the cabling has been damage.
2. check the other three cameras the most simple is to connect the cameras that doesnt work in the terminal that does work!

I have the same problem and I found out that a resistor went bad and then a capicator went bad.you must have them check and replcaced