Where can I get the manual for Jet 3 motorized power wheelchair

Something between the batteries and the motors and joystick is interrupted. Recheck fuses and connections.

The above solution is very good idea one other thing that is easy to over look is make sure the trans engage lever is in drive and if the trans is locked up you can find motor and trans. combo on that site E-b@y I hope this helped.

check the motor brushes if they are 1/4 inch or less replace them. Next, after driving the chair for a while check the motor casing near the brake assemblies on the rear of each motor if the casing is hot then you have a sticking brake pad or pads and this can cause the excess battery drain. If you have sticking brake or brakes unfortunately the whole motor assembly will have to be changed Hope this helps

The power cord you are looking for is just about the same as your power cord plugged into your computer,you can find on just like it at your local radio shack or office depot . Have a good day hope I was able to help.

It sounds like you may have a bad motor. Contact the dealer or manufacturer for evaluation and possible replacement.

Hi. Go to the pride australia web site. You might be able to download a manual. If not then just google pride jet 3 and see what you get. Good luck. Neil.

http://www.pridemobility.com/jazzy/jet3.asp

this should be of help.

Look in your owners manual for the flash code anwser. Make sure when you hit the power button you only touch it for 1 sec not more. If you press the power button for more the 2-3 seconds you place the power chair in LOCK OUT mode. lights will flash and not power. also check your free wheel levers. one on each moter. Mike

Your motor needs to be replaced any questions call me at (866) 598-6230

Check that you don't have the charger cord still connected or the motor disengaged.