08:11 error in hp designjet t1100 - HP Designjet T1100ps Printer

check this llink below Error 21 2 13 on hp plotter t1100 HP Designjet T1100ps Printer

Hello. Designjet T1100 disk failures are pretty common. HP has made it difficult to do anything with their HDDs by securing them with passwords. When a new HDD is installed, it also takes on the ID of the plotter and refuses to work in any other plotter from then on. LPS Computer has T1100 hard disk drives that have been modified to install and work properly and they cost less than HP is asking. They can be seen here: http://www.lpscomputer.com/collections/designjet-t1100-t1120-parts

No. The rib design on the belts are different and they have different part numbers. Both belts can be seen at: https://www.lpscomputer.com/c-2-hp-designjet-repair-parts.aspx

The error code 02.1:10 means the plotter has a communications problem between the main logic board and the carriage PCA. The possible parts at fault are: The Carriage PCA, Trailing Cable, or the Main Logic Board, all available here: Designjet T610 Parts

You can watch this video to see how to remove the covers Designjet T610 Belt Replacement How To Video

The service manual is here: Designjet T1100-T610 service_manual

02.1:10 service station error- failure to reach home position .
you need a service tech to replace the service station within the plotter

this error code is Starwheel Motor failure.
Never Ever Stop Printing - Print Until It Jams

I have this error with my Designjet T1110. I followed the instructions in the service manual 2-14 for troubleshooting.
questions:
- instructions say :"Check that the Starwheel Assembly cable is not damaged and is correctly
connected to Main PCA." but I could not locate any cable from the starwheel assembly to the main PCA. I could see only cable from the starwheel motor assembly to the main PCA.

YOU INSTALL THE DRIVERShttp://cluetechnologies.com/index.php?board=16.0