How to reset PC kit e332n - Lexmark E332n Laser Printer

We would need the secondary codes to get the root cause of the problem. Press the Continue button twice to get the secondary code.

This blinking Toner light indicates that the Photoconductor kits drum is full and is in need of replacement. Please contact our Technical Support Hotline or one of our Authorized Service Provider (click on this link: http://bit.ly/UeQhSB).

hi

go to following link you will have your Printer Drivers

http://bstdownload.com/reviews/lexmark-e332n-monochrome-laser-printer-driver/

Following are the steps that you have to follow:
1. Press and hold Start
2. turn on the printer
- this is service mode -
- by pressing the Start you can print Printer Settings Configuration sheet -

3. press and release Cancel 4 time
4. Press and hold Start while all lights start cycle
5. press and hold Cancel untill all the light cycle
6. turn the printer off to exit the menus
Thanks

turn off the printer open the front cover press and hold the continue button turn on the printer once the error light is solid release the continue button close the front cover. press the cancel button once to turn on the continue button light, press and hold the continue button untill all of the lights cycle to perform nvram reset. then press and hold the cancel button to return to home turn th printer off then back on. should fix your problem

There are rollers inside which you can replace and they NEED to be replaced after a certain time. Part number looks like 56P1820 but i would contact the Lexmark technical support to be sure of the part number and how to order them. It's easy to install, usually it's just clips to pull it out, and you put the new one there.

Remove printer drivers
Printer off.
Disconnect LAN.
Open front cover.
Hold/press both buttons on front, keep holding.
Turn on at back.
Only release button when all lights have stopped flashing, top and bottom light illuminated.
Close front cover
Connect LAN cable.
Reinstall via add network printer - will detect and reset new IP.

You may follow Dell's preventive maintenance on the printer you have, the orange exclamation mark regulatly mean a hault on the printer's operation. The link will show you have to have it cleared and make the printer operational once again.

Dell's preventive maintenance for printers.

The Photoconductor Kit designed for use with Lexmark E230, E232, E232T, E238, E330, E332, E332N/TN, E240, E340 and E342. Yields 30,000 pages.

Have you printed 30,000 pages on this unit? If not perform the following reset:

Procedure for E-232 is:
1. press and hold Start
2. turn on the printer
- this is service mode -
- by pressing the Start you can print Printer Settings Configuration sheet -

3. press and release Cancel 4 time
4. Press and hold Start while all lights start cycle
5. press and hold Cancel untill all the light cycle
6. turn the printer off to exit the menus

If I could be of further assistance, let me know. If this helps or solves the issue, please rate it.
Thanks, Joe


I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309