SOURCE: Behringer B215A replaced volume level knob does not respond.
You DON'T replace the board. If it is cracked, you bridge insulated wires around the cracks and epoxy them down.
Often the pads break from the traces near the pots. Look for a small crack between the pad of the pot and the circuit trace leaving it. Common problem.
SOURCE: my Behringer B215A speaker shuts off after 5
In my B215 there demage HighFreq amplifier (TDA7293) after "CLIP" light on :(. I cant find failure... Anyone knows what wolud happened?
SOURCE: clip light
It sounds like one side of the power amp has shorted. May be hazardous to the speaker so best take it to a shop for repair. If speaker stills sounds OK, probably the clip detector transistors have failed.
2,285 views
Usually answered in minutes!
Can I get a witness? I mean I need an AAAAAAAMEN!!! Not only do I need to save some money on these speakers that were priced closer to what speakers this size should cost, but I also need to save some money on the speakers I bought that were less money than all those money gouger speakers of the hour prices because one of them needs repair. AAAAAAMEN! lol... I guess I could just throw these away and stop caring about them. You know, Walmart style. I mean, who cares right?
×