Having trouble starting it up. I push the power button and nothing happens at all. I even tried draining the power by removing all power sources and holding the power button, but it still didn't work, please help.

try removing power source and opening door

did you hold the start/resume button for at least 3 seconds if this works the dishwasher will start ok but if there is a fault it will fail again best you contact your nearest service agent good luck

It happens when the NB was not properly shutdown, NB was turned off due to battery drained and left idle or worst there is a problem with the mother board. You may try this; Turn OFF the laptop, remove the power sources (ac adapter and battery). Without power sources, hold power button 10 secs. Put back the power sources, and power ON the NB. If the laptop will not boot by doing this, take it back from the reseller for replacement.

hmmm strange first thing id try is resetting the bios it seems it has been effected . remove case remove battery leave off for 3 minutes and replace try then again, while u have the battery out hold the power button on , oh and make sure the power is plugged out, and yeap hold power button for 3 secounds just to drain last of power from power supply. hope this helps

Hello,

Even though a lot of things might have gone wrong and caused this, especially if where you place the System is not well ventilated, and the CPU becomes very hot, it shuts down automatically...and you will have to wait for a few moments, get a cool environment and power it on. but I will also try and tell you some troubleshooting steps that you can try.

Since you have already checked the power source and all is Ok, then try this out:

Disconnect your PowerPack(Power Supply Unit) from the CPU and try to power your PC with another Power Pack (Power Supply Unit), that you are very sure is working.

If it powers up, then just get a new Power Pack(Power Supply Unit) for system.

If you cant do this yourself, just get a good technician to do it for you.

Try this first and let me know how it goes, so as to know the next step.

Hope this helps.
Goodluck!

Did you actually go to the power head and push the program button, then the remote button?

Is there a small wire hanging down from the power head? It's the antenna wire.

I suspect for either of these units that the timer control boards are bad.

I just read this for the same problem: push sanitize, then heat and dry, sanitize, heat and dry, sanitize, heat and dry, cancel, then open and close the door. It worked. The dishwasher is running correctly even as I type this.