Frigidaire Gallery Series Model # GLEH1642DS1 woint spin or agitate

You will need to take the front cover off and check to see if there is anything lodged between the drum and housing.

Here is a site showing all of the steps to disable both buzzers on the Frigidaire Gallery series stackable washer/dryer.

http://www.scribd.com/doc/34420420/Buzzer-Disconnect-Frigid-a-Ire-Gallery

ABSOLUTELY! There is a plastic piece in the back that the center ball piece on the back of the drum spins in. Thats your bearing, replace it.

Hi,
If you are having a problem with your top load washer then check out this tip...

Washing Machine does not Pump or Spin
http://www.fixya.com/support/r4617986-washing_machine_not_pump_or_spin

If you are having problems with your front load washing machine then checkout this tip...

Front Load Washing Machine not draining and or not spinning
http://www.fixya.com/support/r4784376-front_load_washing_machine_not_draining

heatman101

Remove the two support bars from below the washer drum from the front as instructed in the installation manual

Sounds like the bearing is gone, call a repiar man or buy new as repairman 100 per call

Thermal fuse

Check the door switch on the dryer to make sure the leads are all on.Check your thermal fuse .Its likely that its one or the other.

if your washer is digital or with elecronic control board check the the motor control board located at the bottom difiniely you have to call a tech to confirm that. other model like wd5595 and wd 8095 has the same problem and it is the motor control unit that always fails.

Check the thermal fuse, a small disc with two wires on it located at the top of the heater housing at the rear of the machine. If it's blown definitely check your vent system for restrictions