Question about Frigidaire GLTF2940ES Front Load Washer
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
check for kinks in the pipe or restrictions to the flow in the pipes before it gets to the washer, if all is ok then check the filter on the outside of the water connector on the machine for dirt
if you confirm all is clear and the flow of water is not the problem before the machine, replace the cold water solenoid
Posted on Oct 14, 2007
Don't have much experience on Frigidaire. Is the motor a brush type, capacitor type or one of those new DC types? If it's got brushes and they are ok, then I would say your armature is up the creek. If it's a capacitor type (unlikely) then the capacitor is most likely duff. If it's the new DC type it could be a lot of things, most likely the module which breaksdown and passes an AC component in the motor supply which make the motor tremble but not rotate
Posted on Nov 02, 2008
The outlet of the drain hose must be higher than the water level inside the tub--normally the pump inside removes the water when needed. Get a plumber to install a proper height drain pipe for you.
Posted on Jul 16, 2009
SOURCE: Leaks while tub is filling.
could be any number of things: water inlet to tub leaking and running down outside tub,tub seal on top of transmission,pump leaking,bad hose washer remove top and front cover,then plug-in and let it start to fill you should be able to see your leak easier that way be careful when plugged-in
Posted on Aug 02, 2009
SOURCE: Hi, I have a Frigidaire
Hi, if your washer is overfilling/overflows the tub, check these:
Water-inlet valve A defect in the water-inlet valve may mean that it's no longer able to shut off completely when the electricity has been turned off to it. If this occurs, the valve may leak and drip water into the clothes tub. In time, the water may accumulate substantially. If this happens, you need to replace the valve.
Water-level switch A defect--or an obstruction--in the water-level switch may mean that it can't tell the water to shut off. So the machine overflows. This switch senses the water level in the clothes tub. It's usually a diaphragm device with a small, clear tube attached between the switch and the bottom of the washer's outer tub. As the water level in the tub increases, the pressure on the air in the tube increases. When the pressure reaches a certain level, it activates the switch, shuts off the water, and signals the timer to begin the agitate cycle. You can either clear any obstruction in the tube or replace the water-level switch.
Posted on Nov 07, 2010
Tips for a great answer:
May 25, 2016 | LG Washing Machines
on Apr 09, 2010 | Frigidaire Affinity ATF7000ES Front Load...
Oct 29, 2015 | Toaster Ovens
Aug 04, 2015 | Frigidaire Washing Machines
Aug 04, 2015 | Washing Machines
Jul 24, 2014 | Frigidaire GLTF2940ES Front Load Washer
Apr 21, 2010 | Frigidaire ATF6700F Front Load Washer
Jun 18, 2009 | LG Washing Machines
Jun 06, 2009 | Frigidaire ATF6000ES Front Load Washer
Nov 12, 2008 | Frigidaire GLTF2940ES Front Load Washer
227 people viewed this question
Usually answered in minutes!