Inicial programing lock code - Samsung SCH-u430 Cell Phone

Question edited for a lot more clarity, including maker.
Question moved from Misc to Electronic Locks.

Portable programmer according to this

https://www.google.com/search?q=tesa+ht20i+locking+system+program+as+common+user

..

Move big dial to the program where you inicially locked it.
The Key icon will stop to blink and stay on.
Then pres start button for 5 seconds and it is unlocked again

Which manufacturer made the keyless deadbolt lock? Make sure that the batteries are good in the unit.

I have an older Weiser Powerbolt deadbolt lock that is programmed by taking off the cover on the inside of the door. This model has handheld remotes and the keypad. Inside there are three yellow buttons. Two match the cover's lock and unlock buttons. Press and hold the third button (in the center of the set of buttons). Then enter program in the code within a few seconds and press the enter button to set the code. If the unit beeps again, the code is set. If the unit doesn't beep, retry from the press and hold the Program button step.

Another model of the Weiser Powerbolt lock has the Program button either on the top left or lower right hand side of the board (depending on the way the door opens) under the cover. Press the Program button once and then enter the 4-8 digit code. Press the Lock button to set the code. If you hear a long beep, the code was accepted; otherwise try to program your code again.

Kwikset Powerbolt locks are programmed the same way as the second Weiser Powerbolt described above.

Kwikset SmartCode locks have their Program button in the center of the bottom of the control board. Otherwise the programming is the same as that given above for the second version of Weiser Powerbolt locks.

MiLocks have three buttons in a horizontal line. The left-most button is the Set button. Press this then enter the code followed by the Unlock button. The code must be entered within 5 seconds of pressing set.

Baldwin Hardware's Boulder series of keyless entry deadbolts are programmed just like the Kwikset SmartCode units.

I don't know of any videos. Most manufacturers do have PDF files with the programming instructions.

I hope this helps. Please add more information about your deadbolt for extra assistance.

Cindy Wells
(I end up replacing the batteries often on the lock I have; it seems like they last 6 months or less.)

try this code *2767*2878# or *2767*688# to custom reset, it will put your default code (0000 or 000000), otherwise use *2767*3855# but this last will hard reset and you will lose your data, so first try inicial codes.

SE ME BLOQUE EL TELEFONO Samsung Galaxy Spica Gt-i5700 POR PASARME DE INTENTOS DE PATRON DE BLOQUEO Y ME ESTA PIDIENDO Q INICIE SECION GOOGLE Y NO RECUERDO BIEN EL CORREO

How can I program my electronic keypad lock when the instructions with the programming code have been lost?The back plate of the keypad side of the lock on the exterior of the door has a sticker which includes the serial number, six digit programming code and two pre-programmed four digit user codes. The lock must be disassembled to a point the exterior of the lock can be pulled away from the door and the information on the sticker made note of.

This link will give you instructions for various models of Schlage locks:
http://consumer.schlage.com/Service-Support/Pages/InstructionandManuals.aspx

Good luck!

slide the cover off the interior of the door. you will see a program button. you can program two individual codes. to program the first code, press the program button once, then enter your code on the exterior keypad and press the lock button. for the second code you would press the program button twice, then enter the code and press the lock button.

itype *#36466633 and goto misc>highspeed sim>on the mobile was switch off my phone is china mobile

install my webcam without a cd my cd lost