Why cant my print out be print? There is no light on TONER SAVE. So what does it mean? Please help.

You need to replace the waste toner box.
http://www.kyoceramita.co.uk/index/products/consumable/toner_installation.-cps-12303-files-97992-File.cpsdownload.tmp/Toner-2000D.pdf

It sounds like your toner has ran out, so you cant print any more faxes out, the memory saving the unprinted faxes has filled up and cant save any more messages.
Replace the toner and let the machine print out the saved faxes. You should then be back to normal

Hi,
these means that copier cant detect the toner in developing/toner assy.
You should try to reconnect the toner developing assy and try to vacume it.
Also check if the toner bottle is rotating, if yes that means that toner is being dosed and problem is developing assy.

If you do not want to call service write me on [email protected] for service manual.

hope that helps!

Check your print settings by properties. The setting might me on toner save mode so it will print 50% liter or which ever one someone press. It could of been my mistake but it must be toner save mode is on.
Good luck!!
Please rate me good

Rs. 2800/- original carteige
Rs. 1200/- compitable cartridge

You have change the toner save mode first, in the printing window you have a properties options in that you change the mode of printing, if you turn off the toner saver mode in the properties option you can print the documents in normal, dark printing formats. Thank you.

please you service your copier laser unite.
clear your copier cartridge wast toner unite
or setting toner save mode if you are saw on setting off
thanks
Tareq

There's a button on the top called "toner saver". when you press this is prints light to save toner. Press this once to turn "toner saver" off and print normally..

1. Check TONER SAVE setting. If this setting is programmed "ON", all
printed documents will be light.

a. Press MENU/SET, 1 (General Setup), then 6 (Toner Save).

b. Press the top or bottom navigation key (keys located above and below
the MENU/SET key) until the display reads "Toner Save: OFF".

c. Press MENU/SET.

d. Press STOP/EXIT.

2. Check the PRINT DENSITY setting. This setting allows you to adjust
the print density from light to dark.

a. Press MENU/SET, 2 (Fax), 1 (Setup Receive), then 6 (Print Density).

b. Press the up navigation key (key above MENU/SET) to make print
darkeror the down navigation key (key below MENU/SET) to make print
lighter.

c. Press MENU/SET.

d. Press STOP/EXIT.

If the entire page is light, the print resolution setting is too light or Toner Save Mode is on. Adjust the print resolution and Toner Save Mode in the printer properties.

Make sure TONER SAVE MODE is NOT ENABLED!