Machine showing fault number f12

f12 is a error of the module not talking to rest of pcb's,, most probally needs replacing,, either do yourself quite cheaply, or get ripped off from hotpoint,,

Motor Triac has gone ,you will need a new motor.

The simple answer is yes, via a Y piece if it is a hot and cold fill model
The fitting is available from B&Q, or a plumbers merchants

High Temperature Rise in Drying:
check fan motor & filter for blockage. basically a reduced airflow within drum unit

F11 means the pump cannot be activated.You may have a loose conection or faulty pump. For Hotpoint error codes go to http://www.selfix-uk.co.uk

Code f03 means wash thermistor open circuit, this is normally part of the heating circuit, suggest you test heater and thermistos located in the end of the heater, and replace if necesscary. If heater o/k , then could be bad connection to control module, or broken wire, if still no joy, then call Hotpoint.
Please rate my solution.
Thanks.

To fix, hold the Start Button in until it completes the full cycle about 3 mins. It should say end or something similar then start as normal.

hiya
i think this is either the heater or the heater relay on the pcb, i would suggest givin hotpoint a ring though as the machine may come with a 5 years parts warranty so all you will pay is the call out.


hope this helps

please dont forget to rate the helpfulness of this reply, thanks kj

poss uneven floor try adjusting the feet at the front

I read that someone has a problem with F-03 on the display. I have seen this for the first time on my hotpoint wf860 1600 spin. I read the manual the only thing I can think of maybe an unbalanced load in the machine. Albeit the manual is not clear about this. P21 automatic features unbalanced load warning.