Getting Tired Works beautifully, then seems to " get tired": starts printing partial letters. The next morning it works fine, then the same thing starts again.

Shelley,
This may seem like a Captain Obvious comment, however you should see your doctor, not a repair help website.

that is a just acknowlegdement from symentec sir

Contact your doctor. Tell him or her about your symptoms.
I hope and pray you will get better soon.

Check this song out John Denver Leaving On Jet Plane

hi, This is a water temp. problem. The first fill s/b about 125-140 degrees. You can try running your hot water tap for several minutes. Run a load, see if there is some improvement. Next, go to your water heater, see where the setting is. On a gas move dial up a notch. On electric remove top and bottom covers and do the same thing. You also need to clean the dw off and on. Take a gallon of white distilled vinegar and pour the whole gallon into the dw after it has started and run for awhile. Then open the door and let sit overnite, starting the next morning. Hope this helps.

It sounds like a fuel pump and/or fuel filter. Couple of reasons - if fuel filter is partially clogged fuel pump works twice as hard. Also this time of year with big temperature swings condensation (water) forms in fuel tank. If its a weak fuel pump, as pump gets old/tired it won't hold adequate pressure and drains back at night or shut down. Try the fuel filter first and run a good fuel cleaner through it prior to changing filter.

change the ink cartridge & get your printer serviced

mark the ribbon where it turns, where there is a pin of the typewriter passing through the ribbon,mark it with a white marker.
and type something, if it doesnt turn, you know the machine has a problem.
or try everytime pressing on the ribbon, if it works you know the ribbon is coming up, check if the correction ribbon is placed good.behind the correctable ribbon.
unaasp192

re-download the drivers for the printing program that you are using for the job, that should fix this for you. good luck!

It is your disc, it has corrupted data, you need to get another copy.
Hope this Helped.