I have a Whirlpool Heavy Duty washer/dryer stacker. It washes, but does not go through the rinse or spin cycle. I've tried all washer settings, it gets to the rinse cycle, then stops. Does not rinse or spin on any washer settings. Help!!!

hi there.
this is all the info i can find on this.
Key Features

• Catalyst Cleaning Action with Direct Inject

• ENERGY STAR Qualified

• AccuWash Temperature Control

• Variable End-of-Cycle Signal

• 3-Tray Dispenser - Detergent, Bleach and Fabric Softener

• Quiet Wash Plus Sound Reduction System

• Ultra Capacity Plus - Stainless Steel Wash Basket

• 3.8 cu. ft. Capacity

• Multiple Cycles including Whitest Whites, Heavy Duty, Hand Washables and Add-a-Garment

• Multiple Wash/Spin Speed Combinations including High 1000 RPM Speed

• Delay Start

• 3 Temperature Settings

• Automatic Adjustable Water Levels

• Extra Rinse and Rinse/Hold Options

• Side-Swing Door

• SpillGuard Top

• Optional Stack Kit - 8541503
• or see if this link will help you out some more.

What is the capacity of front loading whirlpool washer MO GHW9150PWO...

did you try to diconnect it from wall?

try to disconnect it.... wait for 5 minutes and try to connect it again and try if same problem still occurs....

Sounds like a bad water valve

the main problem is how stable the foundation is for the laundry center when it goes into its spin cycle.

The washer timing control is defective.

It is most likely that you have a faulty water inlet valve. Some machines have a seperate valve for rinse to flush in a fabric softener I suspect that your detergent flushing valve is faulty.....Good luck Nomess

everything needs to be checked from the timer control button to the motor, im guessing it agitated through the wash cycle but wont spin now right? your flood could have damaged any number of items... run through ( with the machine unpluged ) and test the components for continuity and/or resistance.

sounds like faulty timer

sounds like water may be going out but no spin in last cycle lean washer back and ck underneath for oil leak on top off transmission is a silver colored disk shaped object this is part of clutch if there appears to be a lot of oil on it good chance there is oil on clutch also causing it not yo spin..also ck to see if basket spins after short pause at end of rinse cycle ..start a rinse cycle at setting on timer with lid shut allow to run undisturbed ..once agitation stops in rinse timer should stop then start motor back up to drain ..there should be another short pause then washer should start spinning if does not pause suspect suspect timer if it does pause but doesn't start spinning suspect transmission..remember allow washer to advance by itself DO NOT RAISE LID TO CK..a small load of clothes will let you know if washer has spun

if its a 2 piece agitator.. the gears in top of agitator is stripped out.. change gears be like new....spin top countor clockwise if it dont grap.. gears bad