Any one got the universal remote code for a sony bravia KDL-32S3000. Trying to reprogramme my sky HD remote and it will not work the TVguide button.

Try using a cell phone app for Sony.

Check the Video
Amazon Fire TV Stick First Setup and Walkthrough
If you wish to get some details; visit the site linked here. Pull up older posts. http://electro-medical.blogspot.com/

1. Turn on the TV.
2. Wait approximately 40 seconds for the TV to completely start up.
3. On the TV remote control, press and hold the UP ARROW button

Remove all speaker wires and try again. If it unlocks one or more speakers are bad. If not service required for amp. Good luck.

Hello
Remote codes for Sony TV with Sky Plus remote are:

038

533

679

505

533 038 039 064 102 130 505
Ok.

may have a sticky button or a shorted transistor switch.

The cheapest I have found is Videosecu Dual Arm TV Wall Mount Bracket for Sony Bravia 32 37 40 42 46 50... on amazon. I hope this was helpful. regards

Just talked with Sony Support today.

It seems that Sony in Denmark had sent out new software updates (over DVB-T) but also some wrong TV's got updated as well. This caused my DVB-T tuner to not function anymore so I wanted to try a factory reset and it fixed my problem.

So I was instructed on how to do this. I have a Sony Bravia KDL-32P3000 (which should be similar to the U3000 and S3000 as well).

This is how to do a factory reset of your Sony Bravia KDL-32 P/U/S-3000 TV.

PLEASE BE VERY CAREFUL WITH THE SERVICE MENU, YOU CAN EASILY CAUSE YOUR TV TO MAL-FUNCTION!!!! IF YOU FOLLOW THIS GUIDE IT IS AT YOUR OWN RISK!!!

Set your TV in standy (use the green power butten on your remote), RED standby LED is ON on your TV.

Now press these buttons in this order on your remote (pointing to the TV).
i+
5
VOL UP (+)
GREEN POWER button

NOW BE CAREFUL! Dont press any keys just for the fun of it!!! IT MAY DESTROY YOUR TV.
You should now be in the service menu. It will show up as some green letter/numbers spread over the screen (mine are a bit hard to see/a bit faded). In the upper right corner you should have 2 letters TT (two t's).

Now carefully press key 0 and then key 8 on your remote (they should be shown on the screen after the two TT).

Now wait a little while (more than 10 seconds) and your TV should reset with factory settings, just as if you had just brought it home from the TV store.

Best wishes,
Mads

You will need a code in order for the tv functions of you sky remote e.g volume to work.

Click here to find out what remote control version you have.

If you have a remote control was produced after 2002 or there is no sticker

click here to use Sky's code look up tool.

Most SKY+HD Remotes are produced after 2002

1. Press tv on your Sky remote control.

2. Press and hold down select and the red button together until the red light at the top of your Sky remote control flashes twice.

3. Press tv again

Then enter the remote control code using the number keypad. The red light will flash twice if a valid code has been entered.

Sony Code: 0000

4. Point your Sky remote control at your TV and press the Power button. If this turns the off as you'd expect, then the tv should be set, press Select and the remote should work

5. If the TV does not turn off press tv, then press the Power button again, repeat this process until the TV turns off, when the TV turns off press Select.