While walking on my tredmill the belt jerks - RTO Image 15.0R Treadmill Walking Belt

the belt has two rollers the front one has a motor roller adjustment screw like the one on a car alternator; tighten this screw untill the rolller grips the belt.

It means ur Belt is starting to rip and it It is probably getting tangled
up in the motor so it burns and smells or something is in the tredmill like a blastic bag or something so I would look at that

will be better that you replace go to www.fitnessrepairparts.com and get it. or www.treadmilldoctor.com

God bless you

Hi,
Try to tension the Walking belt. If the walking belt is not in tension then the belt will stop when you step on it. Watch the video to find how to tension the walking belt. Every treadmill follows the same procedure.

You are needing a new walking belt .....see the troubleshooting link below:
http://www.treadmilldoctor.com/Shuts-Down-During-a-Workout?utm_source=yahoo%2Banswers&utm_medium=CPC&utm_campaign=Mendi

yes you can go www.fitnessrepairparts.com or www.treadmilldoctor.com
and buy it.

God bless you

Inspect the walking board and belt first.Feel the tecture at the outer edge of the belt, then feel the center. If it feel fuzzy, the walking belt is worn.
Check the walking board for damage, deep scratches, excessive friction will cause an over current shutdown of the controller.
If the walking belt and board are good, lubricate the walking board and belt and try again.
Does the motor spark allot when running?? This will also cause over current.
Have you tightened the belt (too tight??)
After covering these suggestions, if the same problem is apparent, change the motor controller..

You need to insert the safety key without it, it is not going to work

That's an embarrasing admission. A treadmill works like a conveyor belt or a car's fan belt. If it is too loose it will slip under load. There will be an ajuster on your treadmill. All you have to do is tighten the belt. Do not overtighten it though. an

I centered the belt on my tredmill and now it wont move at all. I tighted and loosened the belt. motor runs belt wont move