TV is plugged in but won't turn on. Tried unplugging for a bit then trying again, nothing. Tried flipping the i/o switch next to the a/c in to no avail.

Switch off the TV from remote, then switch off the on/off button on the TV, remove the plug pin from the power outlet. Cool off for 48 hours and then retry. If nothing works, better refer it to a qualified service technician.

the green light blinking is normal if set has been unplugged--when set is plugged back it should blink for about 70 seconds and then go out--then you can try to turn it on---it is the DM unit inside the set booting up.

If the light just blinks and never stops you have likely bad caps in the DM unit---there are kits available for that.

The other possible reason is that so called reset switch may be bad--fairly easy way to find that out and it is more common than you would think, let me know if you have questions.

SD TECH

Hi, Nan.

Disconnect the power adapter, flip the laptop, unlock and remove the battery. Then, reinsert and lock the battery, connect the power adapter and try again.

Hope this helps.

I found the solution for mine with the same problem, not sure if it works for others. What I did after plugging it ti my mac with no results other than it staying on when I removed the batteries, I go the idea to hook it up to my windows laptop without the batteries. After that I put the batteries back in (for no reason) and my computer installed the driver for flip again and found the videos that were left on it. I quickly saved these as I wasn't sure what would happen next. After that it had to restart the flip software so I let it. I then unplugged it from the computer wondering what it would do next...(nothing). Well after saving my videos I figured I had nothing else to lose so I pressed the (PLAY+FORWARD+HOLD DOWN THE ON BUTTON) a quick flash and I was watching my videos that I had saved earlier. Like I said not sure if it will work for you but did for me. I sure pays to keep fiddling. :)

Im seeing this problem alot here is someone elses idea. I'd try a full power cycle, all firmwares are bit for bit the same so thats not your issue. Try flipping switch on back/unplugging/plugging back in/flipping switch/starting it back up.

If you dont have the led light on when plugged go ahead and replaced the powerboard, but if your led light is on when plugged then you will need to replace the mainboard.

Hope this info help you.

Try to read your product manual caferfully all information are cited in the manual in order to have a smooth operation of your unit.

Hi there!

I work in an electronics store and I've come across this problem before. The only solution that has ever worked for the people who call in or come to see us is pretty simple. You need to unplug your PC from the TV (if you haven't already done so), turn the TV on by using the "channel +" button. Some TV's when turned off at the wall will not turn back on again unless you press the channel + button. Give it a go and see what happens. Let me know if you need more help.

Also, it sounds like your laptop may not have been supported due to the wrong resolution being outputted through your VGA connection. When you get your TV turned on again I'll see if I can help you get them to work together,

Cheers and good luck!

Abby.

I have the same problem. The only way to get the TV to come on is to unplug it, but once you get it back on it turns itself off again in a few minutes.