I have a compaq v2000 and what Im tryin to do is conect my Mbox mini and the Xenyx 1002 to the laptop is that posible ? how can I do that ?

question edited for a lot more clarity, 'make model (what it is)'.
Question moved from Cellphones to model category.

The schematic is here

https://www.synthxl.com/kenyx-1002/

Service Manual

https://www.google.com/search?q=xenyx+1002fx+service+manual

..

You can download a copy here-
BEHRINGER XENYX 1002 SCH Service Manual free download schematics eeprom...

The main output jacks of the 1002 are PSUEDO balanced so you can use TS to RCA connections from the 1002 to the MK4. It is not hte best design, but it will work... with two cables go from the 1002 main outs to the stereo ins of the MK4.

Assuming you are on a Windows system, go to Control panel/Sounds and devices/ and check that the Mbox2 appears as the default in the Audio and also Voice tabs/panes while unit is connected. If it is not, select it in each... if it is not in the list offered, then the drivers have not been installed for the Mbox.

Fuse would have NOTHING to do with the problem. Make sure to use balanced audio lines... XLR or TRS to mics or other devices.

You need to by cable mini tip to XLR or to 1/4 inch TRS connector. Any guitar center can hook you up w/right cable it's a simple thing.

Try this:

http://elektrotanya.com/behringer_xenyx_1202.pdf/download.html

This is for slightly different model, however Behringer uses same circuits in most of this series... AND they don't give out schematics.

You can't do any damage... just try plugging into the line... If the mic has enough output it may work. Balanced line mics are best though...

You must connect:
the main out of the 1002, or the ctrl room out of the 1002 at your power amplifier's input.
the line in 9/10 of the 1002 at your 2496's line out.
the cd/tape out of the 1002 at your 2496's line in.
in case of a cd connect it's line out at line in 3/4, or line in 7/8 of 1002
some mic at the mic 1 or mic 2 of 1002.
That's the way you're going to have control for:
the mic level from channel 1 or 2.
cd level from channel 3/4 or 7/8.
pc playback from channel 9/10.
master speakers from main mix or ctrl room.
All the above connections are not absolute and may vary depending on your needs.

In case of a problem or clarification, don't hesitate to post.

Thanks and regards
Please kindly rate this solution
Stelios

It is possible, you can simply put a Y-cable for Mic or a splitter for the mbox and the Mic. You can plug the mic directly to the mixer then the other jack on the splitter connected to the mbox.