How to Configure Symbol terminal PDT 3100

1. hi,
   

   please follow the given link ,you wil find the solution of your problem ,step by step.
   

   please also follow the instructions.
   
   
   

   http://www.ehow.com/how_7184696_reboot-pdt3100-symbol-barcode-scanner.html
   

   Good luck
   

Does anyone know if the Symbol pdt 3100
Has gone flat if the data can be recovered ?

You'll need the manual for that. Here's a link to Symbol's site where you can select the documentation you need. You might need to cut and paste the address into your browser's address bar. Good Luck.
http://support.symbol.com/support/browse.do?WidgetName=BROWSE_PRODUCT&TaxoName=SG_SupportGoals&BROWSE_PRODUCT.isProductTaxonomy=true&BROWSE_PRODUCT.NodeId=SG_PDT3100_1_2&BROWSE_PRODUCT.thisPageUrl=%2Fproduct%2Fproducts.do&id=m4&BROWSE_PRODUCT.TaxoName=SG_SupportGoals&NodeType=leaf&NodeName=PDT3100&document=DT_PRODUCTMANUALS_1_1&BROWSE_PRODUCT.NodeType=leaf&NodeId=SG_PDT3100_1_2&kwidget02.docType=DT_PRODUCTMANUALS_1_1&AppContext=AC_ProductPage&param_document=sp

To configure the terminal Ctrl-C to drop you to a DOS prompt then type cfg11 this will then take you a configuration screen where you can enter wireless and IP settings.

I can’t say about what program you are trying to load. If you get the system to associate then the next step is to configure the host settings.

FUNC-CTL-R at the Connect to Host screen

Password: system

Then you can add host settings.

It’s a shame we fix PDT6846's all the time and if we replace the board reconfigure them for the customer.

If you need any more help then please do not hesitate to contact us:-

http://www.biastechnology.com/

or TEL 01202 620955

You have to unistall the program that is inside unit you purchased and load one you are using. I can help you during this configuration. You can always contact me by phone or email 630-622-2024 [email protected] Please visit our website www.legacyglobal.com

We have all sofware that you need, obviously I cannot post them here so please contact us. You can always contact me by phone or email 630-622-2024 [email protected] Please visit our website www.legacyglobal.com

Contact Symbol Support at 1-800-653-5350

The terminals use DR Dos as operative system. Anything you want to download to them normally has to be built into a hex file and you will need a cradle, a null modem cable and winhex or the old dos command called sendhex.exe.

Is it a pdt 3100, 3140 or 3146?

I can send you the operative system files if the terminal is a 3140 or 3146 or you can do a search on the web for LWP and UPD.

We hava a Symbol PDT 3100 barr reader. It worls properly picking up bar codes fron our inventoy, however we don´t know hoy to dowload them to a PC. ¿Is there a software or configuration to download the data to a PC? Thanks for your help Jos? jalal