I need a guide on how to change the belt on the crosswalk GT model no. 297390. Do you have a guide or manual that would help. thank you.

Question edited for maker name.
Question moved from Building Materials to a Proform Crosswalk category.

Either the belt is too slack or it needs to be reset.

https://www.manualslib.com/manual/672296/Pro-Form-Crosswalk-395.html?page=20&term=reset&selected=9#manual

..

Manual troubleshooting may help link below
https://www.manualslib.com/manual/751256/Gold-S-Gym-Crosswalk-570.html?page=22

https://www.justanswer.com/fitness-equipment/7aari-gold-gym-crosswalk-570-treadmill-will-not-start.html

https://www.youtube.com/watch?v=Bu_SEUU2umo
https://www.youtube.com/watch?v=XZPkzt3lRgo

https://www.fitnessrepairparts.com/equipment/Select/19878/Golds-Gym/Crosswalk-570-GGTL596080

You can get parts from some websites:

http://support.proform.com/


PROFORM PROFORM CROSSWALK 480 Parts Model 831248242 Sears PartsDirect


ProForm Treadmill Parts


Proform CROSSWALK 390 831 248230 Fitness and Exercise Equipment Repair...



Repair Parts for ProForm Crosswalk 395 Treadmills Belts Safety Keys Mats...




PROFORM SUPPORT

You will need to loosen up the right side one revolution, then run the belt at .5 revolution. Watch the belt then retighten the right side slowly until the belt stays in the center. Once its running in the center for at least 1 min without moving over more to right you can stop tightening.

Exercise equipment service Treadmills Ellipticals and Bikes Parts Assembly...

proceed according. God bless you

see the video and proceed according LUBE the rollers bearing TOO.
God bless you

lube the deck belt, you have deck worn, proceed in according with the instruction manual maintenance. 2) check the drive belt and replace it if necessary and tight 3) tes the input voltage motor, if there are the motor need repair or replace 4) test the output voltage from main board, for input voltage for the main motor, if there are NOT, the board is faulty.
Try if you can RUN the software calibration for diagnose and troubleshooting.
sincerely. God bless you.

Check this site for your guide to change a belt on your machine, you can explore for some information on how the machine part working...

http://www.searspartsdirect.com/partsdirect/part-model/Frigidaire-Parts/Dryer-Parts/Model-AEQ7000ES1/1428/0151200/R0606015/00001?blt=06&prst=&shdMod=

Here is some info that will help:

You need this belt:
Eureka SurfaceMax 300 Belt

This is the manual with instructions:
Owner's Guide

http://www.iconservice.com/pdf/297390.pdf