My washer will fill up, but will not spin or rinse. The belt also keeps slipping off

Thank you for your inquiry, friend!

Based off the information you have provided your Frigidaire washer keeps filling with water then will spin out and shut off. This sounds like an issue with your water valve or control panel. I would recommend performing a reset on your washer and you can do that by flipping the household circuit breaker off for at least ten minutes. If that does fix the issue you may want to have a professional technician out to perform a proper diagnosis. Hopefully this is helpful information. -Matt

You either have a bad solenoid, timer, loose belt, or water level sensor.

hi
take look at the "V" belt that drivers the drum insure is not slipping

Check for a belt. it may be worn or slipping.

Fill setting has to be adjusted and the belt is slipping on the spin cycle and not generating enough centrifugal force to get the water out.

sorry to keep asking questions but i just need to know a little more information. are you using auto fill? have you tried manual water level settings? is your machine the one with the LCD DISPLAY?when it stops at rinse, is it agitating? if you have the LCD display have you tried the- traditional wash mode? please reply 4 further help.

Dear customer,

              We recommend the following when a washer's cycles dont advance..

1. If the washing machine fills with water and begins agitating, but the timer does not advance, the timer probably needs to be replaced
   
2. If the timer does not advance while the washer is in a spin cycle, the timer probably needs to be replaced
   
3. If the timer does not advance during the rinse cycle, check whether water has filled the tub, if not, it is likely cold water related. Check the cold water supply valve, check the supply hose for kinks, check the filter screen and check the water inlet valve
   

For details on how to self test these parts plz refer to http://www.acmehowto.com/howto/appliance/washer/washer.php
Plz rate this solution.. thank you.. 

Check your washer belt has not slipped off.
Just so you know thats not the problem.. Ours went ga ga and it was only the belt!

:o)

Hi this could means that you may need to replace the washing machine bearings. Once the bearings are bad, the motor overheats and it will automatically shut down after the first rinse.

Timonty from WashingMachineAdvisor.com

gabehart....sounds like belt is slipping. Replace it. The water pump is on a separate smaller motor so is not affected by the agitator/spin motor.