What is the capacity of the washer wjsr2080t6ww?

The 27 series are typically 4.5 cu ft.

https://manualzz.com/doc/2128222/kenmore-3.2-cu.-ft.-king-size-capacity-top-load-washer

..

Hello,

This youtube video will show ya who to remove tha agitator (and replace the agitator coupling)
http://www.youtube.com/watch?v=N26MCQKuXn0

GENE

There are 4 common possiblities. 1. Hose from tub to pump has a hole in it
2. Water pump is leaking
3. tub seal has gone bad
4. Water fill manifold has a hole in it

1,2,4 is an easy fix
3 requires removal of the inner tub (not an easy job)

The agitator just snaps onto the drive block, you gotta grab it by the neck and get mean with it.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Try to move the base of the agitator, if you are able to move it freely then you probably have a stripped coupler which is under the agitator and attaches to the transmission shaft.

might be a transmissin problem, ive seen the brake get too tight on these units to allow spin

Starting in early 2002, the capacity sizes were changed around a little bit. A normal sized washer now all have the same sized tubs (pretty much) in the 110 series (Whirlpool Manufactured) washers. The capacity is now rated somewhat by the agitator action the washer comes with. Depending on the type of agitator you have, will determine the capacity. King size capacity means you have a pretty good capacity (size wise) than others. You have normal capacity, large capacity, super capacity, king capacity, and I even think they have canyon (yes canyon) capacity. Capacity sizes dont really mean to much though. In order for you clothes to get clean, the must have room in the tub to move. The must be able to float up, then get pulled down by agitator action. That should determine the size of what goes in the washer. Always use same type clothing when doing laundry (i.e. towels with towels, sheets with sheets, etc, this will keep the load balanced better). Watch what you load, comforters are ok (per manufactures ok) but I do not tlike the idea unless its a front loader, and only by itself. Let me know if this helps you out any.

Sounds like something is stuck in the drain pump, maybe a sock. Remove the front panel by sticking a small screwdriver or putty knife just above the front panel to release 2 clips. Drain pump is located bottom right with 2 hoses connected to it. Drain the machine and remove the hoses. Check for obstructions.

The problem was two out of three broken spider arms. Shame shame on GE for using Frigidare parts and using aluminum for a washer part in the fist place, also not listing the matinance needed to clean the filter in their manual. So they can come clean it for you, at a cost of $69.00? Seems so. And refushing to sell the broken part separate from the drum. Though the part itself was under warranty we had to pay for the labor of a poorly manufactured part that is a well known issue. See (Why Kenmore front load washers fail) on You Tube. There is a nice video of the spider arm SCAM!!!!!! We need to speak out together or the problem will continue.