Kyocera FS-1028MFP has been set to SMB network authentication and will not allow login to html or panel. Need to reset printer back to factory to access and reconfigure.

just turn off authentication mode using admin login

smb scanning? check to make sure host ip is conrrect as well as long in info and path to folder /email make sure smtp server address is correct along with login info and try port 587 if its set on 25 comcast tends to block 25 for smtp scanning

usally the speed of the machine with two zeros or try Admin or Admin00

u130 dev unit set up and u251 clear main count

try formatting the hdd

Apparently there is a communication error between the printer mail server. Can you ping both reliably ? Is it an internal mail server ? If yes, can you ping the printer from it ? Did you try changing the network cable ? How about IP addresses ? Could there be a conflict ?
Cheers,
Franck Horlaville TAM Software

3101: SMTP Authentication error. Consult with Your network
administrator to verify that your Login Account, Name and
Login Paswrod required for SMTP Authentication are correct.

Your printer comes with a software CD. Run the CD there's an option to reset the printer.

hi
i think this is
http://www.kyoceramita.eu/dlc/eu/documentation/usermanual/fs-1028_1128mfp_operation.-downloadcenteritem-Single-File.downloadcenteritem.tmp/FS-1028MFP_FS-1...8MFP_OG_ENG.pdf

Try 6482 or MITA as password
Try leaving password box blank

Try entering the IP address in the web browser and configure there. The firmware will have to flashed if this doesn't work.

Kyocera is pretty picky about resets. You might have to phone them.

1800-GET-MITA