How do i remove the stand/base off a panasonic viera TX37LZD70 37" flat screen tv so I can wall mount it?

Panasonic flat panel televisions are packaged with a small television stand that users can attach to place the television on a flat surface. Some users, after attaching the stand, would prefer to hang the television on a wall instead. If the stand is still attached to the Panasonic TV, you cannot hang the television on the wall. Remove the stand from the TV to hang it on a wall.
Step 1
Unplug the power cord from the electrical outlet and lay the television, screen down, on a towel. The towel helps prevent damage to the screen. Step 2
Remove the four retaining screws that secure the stand from the bottom of the television using the Phillips screwdriver. Step 3
Slide the stand out of the television. Place the stand and the screws in a safe place in the event you change your mind and decide to set up the television on the stand again. The television is now ready for hanging on a wall.

You maybe lucky, but make sure the mounting holes on the stand matches your TV.
Alternately you can use a wall mounting and these have mounting holes that suit most TVs.

Unscrew the base screws attaching the base to the TV set, once the four screws have been removed, the TV can be seperated from the base as shown below. The circles are where the screws were on mine before I removed the base.

Yes you can remove the stand from the television for wall mounting purpose.Just unscrew the four screws marked by the yellow circles. Lift the TV up while somebody holds the base down or it will lift along with the TVand fall. Make sure you take help from one more person while doing this.

My ex-husband threw away the pedestal stand for the Polaroid Polaroid FXM-3211C TV DVD Combo which I now have. I need a pedestal stand....do you know where I can find one?

theres 4 fixing mounts at back of tv covered by plastic caps just remove those to mount

you have 4 screews to remove on back of your tv. 2 each side of connector panel

the TV will mount to the wall via the VESA screw mounts on the back of the LCD. If it is a smaller, monitor sized LCD then the screw pattern will be either 75x75mm or 100x100mm. On larger TVs is it usually 100x200mm. Sometimes the base is screwed into this mount and othertimes to the bottom. Simply unscrew it from the screen. Be sure that the wall mounting kit can handle your LCDs VESA screw pattern, screen size and screen weight.

TX 32LXd60
Lay the tv face down on a flat surface. Do not scratch the screen ! Use a cloth.
Remove the 4 screws above the stand. Pull stand out. Replace screws.
You can get Operating Instructions from;
http://www.panasonic.co.uk/html/en_GB/Support/Downloads/220239/index.html#anker_220239

enter the model number- click search- and download the Operating Instructions . The Operating Instructions will illustrate the stand.

There's a little more elaboration required on the above post...You need to remember that the base has two long pins that go up into the TV. These pins are held in by two screws each. The screws are on each side of the TV (two vertical inline screws, inside a small inset section). Remove all four screws and the TV will come up off the base. Pull it straight and gently, but firmly, to unseat it from the pins.