It is a door lock failure and it flashes after the door locking routine fails to lock the door after 6 attempts. Replace the door lock/latch assembly (part number 8182634) to solve the problem.
Disconnect
power to the washer and open the door. Remove the door gasket retaining
hoop by stretching apart the retaining spring at the bottom of the door
opening. Gently peel the part of the door gasket near the door
lock/latch assembly off the lip of the right side of the door opening.
Remove enough of the door gasket to access the door lock/latch assembly
behind the front panel.
Remove the three screws securing the door
lock/latch assembly to the front panel and slightly lift it then pull
it back off the front panel. Pull the door lock/latch assembly out of the washer and disconnect the wiring harnesses.
Connect the wiring harness to the new door lock/latch assembly and install it back in place behind the front panel. the door lock/latch assembly and put the eased part of the door gasket
back into position over the lip of the door opening.
Check that
the door gasket is properly seated before putting back and securing the
retaining hoop around the lip of the door opening and the door gasket.
Hello and welcome to FixYa
DL f is a door lock error and is caused due to an
issue with the door lock when it is unable to lock/unlock. Please check the
door lock mechanism/door switch assembly and replace the part that has gone bad
so that the issue is resolved. Please get back to me if you have any other
questions.
Kevin
1,839 views
Usually answered in minutes!
×