I have an error code S2. what does that mean?

O2 (B2 S2) Heater Circuit High (B2 S2 means bank 2 sensor 2)

Sounds like the rear O2 sensor on the passenger side is bad or unplugged.

Hello to all
I have a client server ir Pass has forgotten his password and I reset.
how reinitialiser server S2 canon ir Pass?
Thank you for the help.

To unlock SAMSUNG GALAXY S2 use unlock code...Visit the site WWW.THEUNLOCKARENA.COM get unlock code and unlock it from network lock easily.To buy code you need to specify current network,country it is locked now and get code unlock it....

Samsung Galaxy S2 Unlocking InstructionsWarning : Do not enter any wrong unlock codes on your Samsung Galaxy S2 mobile phones. If you enter over a certain amount of wrong unlock codes on your Samsung Galaxy S2 mobile phone, your phone may get hard locked and sometimes become unusable.

1 - Switch ON your Samsung Galaxy S2 with a NOT ACCEPTED SIM Card.
2 - Compose : #7465625*638*CODE# (or *#7465625*638*CODE#).

NOT ACCEPTED: We mean, to use a sim card from a network other than the network your Samsung Galaxy S2 is locked to.
CODE: Its the unique Unlock Code for your Samsung Galaxy S2.

You need to post the ERROR code.

The S2 IS uses SD cards. While SDHC cards will fit into the slot, they are electronically incompatible and will not work. While you can use SDHC cards with the SD750, you will have to use SD cards, 2GB and smaller, with the S2 IS.

Your Regency scans (samples) the programmed frequencies at the rate of approximately 15 channels per second, so it is constantly checking for an active frequency. "D-code" code refer to any of a number of things. Do you have the term in context?

Where is a beter place to download drivers for your MB other than this?
http://www.gigabyte.com.tw/Support/Motherboard/Driver_Model.aspx?ProductID=2755&ost=xp#anchor_os

Select your OS from the dropdown list in the middle of the page.
Seems like you have a Realtek Azalia audio chip.

Call a good TV Tech and tell him about a Sony Recall on this TV concerning the S2 Thermal IC and Fuse.This causes the 9 blinks.It is an error code. S2 Thermal sensor IC and fuse
S2 Thermal sensor IC and fuse

your system is failing it's Power on Self Test (known as POST) the beeps are a code which tells you where it is failing. unfortunately the codes mean different things for different motherboards, however common faults include Graphics card fault (try reseating) and Memory failure. If you look at the Manaul for the tx300 S2 there is a section on the diagnostic LEDs, I suggest you have a look, as it may help to diagnose your problem (it can identify faulty components) http://manuals.fujitsu-siemens.com/serverbooks/content/manuals/english/thb-d1899-d2099-en.pdf