Question about Hoover HTC243 Top Load Washer

1 Answer

Hoover 500m top loader won't drain water out. It used to leave some water in occasionally, now nothing comes out.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

My washers phu cked and now im going to nave to replace her

Posted on Jun 07, 2017

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
IFIXALL

Archie Ferrarini

  • 869 Answers

SOURCE: LG Top loader not draining water to rinse and spin

YOU NEED TO CHECK THE WATER PUMP,SO LAY THE MACHINE ALL THE WAY DOWN ON ITS FRONT,NOW YOU HAVE ACCESS TO THE PUMP.Remove any debris that may be lodged inside of it.

Posted on Jun 09, 2008

Anonymous

  • 734 Answers

SOURCE: Daewoo Top loader washing machine water wont drain...

hi friend,
If your washer won't drain, check these:

It spins, but doesn't pump
It doesn't spin or pump
It pumps, but the water returns
It spins, but doesn't pump
If your washer spins but doesn't pump the water out, the drain line is probably clogged. In many
washers, a small sock or other piece of clothing can get between the clothes tub and the outer tub
that holds the water. If the clothing gets between the tubs, it may then get into the drain hose that's
attached to the pump--or even into the pump itself. If it's in the pump, you need to remove the
hoses
from the pump and pull the item out.

To remove the sock from the outer tub port, open the washer's main access panel and remove the
large-diameter rubber hose that connects the pump to the bottom of the outer tub. Then, using
needle-nose pliers, try to grab and remove the clothing through the port.

Sometimes you can't remove the stuck clothing from below. Then you have to remove the agitator,
top of the outer drum shield, and inner clothes tub. This isn't easy to do--and you may need special tools--so you might
be happier getting a qualified appliance repair technician to do the job.

If the drain line isn't plugged, the problem may be with your pump. Even if the pump appears to be
turning, the internal impeller may be broken. If so, you need to replace the pump.

It doesn't spin or pump
If your washer doesn't spin or pump water out but the motor is running, your washer probably
has a frozen pump pulley. If so, you need to replace the pump. To check the pulley, remove the
pump from the washer and try to rotate the pulley manually. If it doesn't turn freely--if it's frozen
or stiff--replace it.

It pumps, but the water returns
If the water that pumps out of the machine goes back into the machine after the spin cycle, your
washer may be siphoning the water from a laundry tub that has a slow drain, back into the
washer. The usual remedy for this is to improve the draining of the laundry tub. (Is something stuck
in the drain?) Also, check for these problems:

* If the drain hose reaches more than about 4 inches into the laundry tub, cut off the excess.


* If your drain hose is lower than the washer's cabinet, install an air gap/siphon break assembly.

Posted on Dec 12, 2008

James Chandler

  • 686 Answers

SOURCE: have a roper ras7133kq1 top loader. It will fill

go to www.repairclinic.com and enter your model number. the first part you see is what is wrong with your washer's spin. replace that and you'll be good. this is found underneath between the motor and the transmission.

Posted on Apr 03, 2009

Anonymous

  • 87 Answers

SOURCE: my frigidaire front loader washer will not fully

An e20 error is a slow drain. Basically you have a clogged pump. I just had to unclog one today! Unfortunately they are a little hard to get at. Usually they have a small sock or coin stuck in them. The pump is located in the right back. Good news, no cost to fix, bad it's just going to take some time.

Posted on Jul 07, 2009

heatman101

D. Floyd Kolb

  • 43501 Answers

SOURCE: LG Top Loader Fuzzy Logic 5.5. The water

Hi,
No you just need to get the drain hose up higher...the water is siphoning out and is either caused by the end of the drain hose still in water and not having an air gap or the hose is not going up higher then the top of your washer...
Lifting the hose up should give you an air gap and get the hose high enough to stop the siphoning...

heatman101

Posted on Apr 28, 2010

Testimonial: "I am extremely impressed that this won't cost a call out service fee. . . and looking like a bimbo. thanks, heatman!"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

IS THERE A SCREEN THAT HAS TO BE CLEANED MY CLOTHES DO NOT SMELL GOOD WHEN THEY COME OUT OF MACHINE


If yours is a front loader it's recommended to leave the door open when you're done. Also check and clean out the drain holes inside the lower area of the rubber "bellows". Use hot water and bleach occasionally to kill bacteria. If it's accumulated a buildup you can treat it with commercially available products.

Oct 06, 2014 | Washing Machines

1 Answer

Water level control on Hoover 205 top loader


as long as it fits on it will be ok ..pressure not to much

Feb 06, 2014 | Hoover Washing Machines

1 Answer

Hoover 500m top loader washing machine fails to stop at 'OFF'


timer and dont think u can get them any more

Jan 18, 2013 | Washing Machines

1 Answer

My Hoover 500M top loader is very noisy on the spin cycle intermittanly. It sounds like a faulty or dry bearing, maybe when the water pump is emptying the bowl. The noise stops as soon as the spin cycle...


First I would bench check the water pump and see if it is operational or not. If it is then I would check the transmission. When it is in the spin cycle it switches to the high speed, so if you hear the grinding only in the spin cycle it could be the high speed gear.

Do you have any indication of a transmission leak? Fluid on the floor or on the transmission?

Jun 22, 2011 | Hoover Washing Machines

1 Answer

Water wont go out of my top loader


Check the drain line for kinks or obstructions. Check the pump. Remove the hoses from the pump and use a flashlight to look into the suction port. Make sure nothing is clogging the pump, like the occasional stray piece of clothing, and check the pump impeller. Make sure there are no broken or missing blades and that the impeller will spin freely. If any blades are broken/missing or if you can't get the impeller to spin freely, the pump is defective. Hopefully it's just a clogged drain line, pump, or jammed impeller. Really sorry for your trouble and I hope this helped. Best wishes.

Oct 14, 2009 | Hoover HTC243 Top Load Washer

2 Answers

Hoover 2305 washine machine wont spin


hi, i have a hoover 500 mb, occasionally it will not [ click into ] the wash cycle, then gets confused and does not spin dry properly

Jun 24, 2007 | Hoover HTC243 Top Load Washer

Not finding what you are looking for?
Hoover HTC243 Top Load Washer Logo

Related Topics:

492 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hoover Washing Machines Experts

peter gittos
peter gittos

Level 2 Expert

247 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1481 Answers

Poppa Maddo
Poppa Maddo

Level 2 Expert

372 Answers

Are you a Hoover Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...