Works fine for 10-15 minutes, then screen goes gray/black and the input flashes in top right corner (alternate gray/black screen and input display). turn tv off, then back on several minutes later - same thing.

It might be the input from the graphics card. Try swapping the two monitors' feeds to see if the problem is with the monitor or the card. The monitor seems to be going into a screensaver mode since there's no signal. The flashing light could mean there's a power supply problem, or no signal.

Hi this is naturally a late solution, as I can give you my broken LCD set and maybe you can transport the screen over and Have a good working set.07404690865 My 3year daughter broke my set. Powers up fine and displays through the cracked lcd.

Hope this is useful.

Buy another HDMI cable.Try another HDMI cable with another HDMI hub on the tv port.If u still have the same problems,mean the whole main tv Tuner signal board have problems and the caused.Tries websites like Shopjimmy.com,Ebay.com to buy a whole new refurbish tv Tuner signal board for the replacement.

Not working right. Take it back and have it replaced. It's new as you said, right?

check the scart cable/adaptor

First try to reset factory settings of your phone. If not solved it need to be flashed.

my camera has a gray screen and a black line at the bottom right corner and you can not see any thing you are looking at. what do i do!!!!!!!!!!!!!!!!!!!!!

it is just saying what input you have it on and what level of hd your getting (480i 480p 720i 780p 1080i 1080p)

I have the same problem. The next stage is that the picture won't come on at all and the blue light will constantly blink. I think the light source is bad. Noit sure though.

Hola Guate ;] display cable is probily loose. Seen this problem on another model. Don't know if it's the same for the V3, but you have to make sure the screen cables are well connected. this is how it goes with a different model: Open the back of your phone, and near the top right side is a cable that leads to the screen. Make sure it is fully in. If this doesn't work, open the face of the phone, carefully remove the metal peice that is on top, there are small white latches on the side. After that you should just see the red-brown cables of the screen. To the top right corner there should be a cable that looks alot like the one in the back. Make sure that is all the way in. Good luck, tell us how it went in there...