Jvc kd-sc500 cd car stereo

By any chance , did you check all the speaker wires,
, could just be a loose wire at stereo or at speaker.

when i go to connect my power supply nothing happens the jvc will not turn on, but when i connect my old pioneer it works, what is going on?

Wife bought me a new JVC KD-S16 in dash cd player/radio. Is this a good unit?

First step: pop a huge one.

Follow this 3 steps :

Step 1 : You mast find the dc motor inside the car radio.
Step 2 : Desolder the 2 wires of the dc motor.
Step 3 : Connect the 2 wires to a 12V DC source, if the CD do not come out then reverse the wires.

I had this same problem with a sony deck. Try ebay and search wiring harnes for JVC KD-SC500.

Press and hold SEL (select) for more than 2 seconds so that one of the PSM items appears on the display.
Set the hour.
1 Select “CLOCK H” (hour) if not shown on the display.
2 Adjust the hour.
3 Set the minute.
1 Select “CLOCK M” (minute).
2 Adjust the minute.
4 Finish the setting.

Please make sure to rate me.
Thank you

http://books.jvcservice.com/booklist.asp?Model=kd-sc500

you need the jvc cable compatable for that unit

Hi, Normally, your JVC Car Stereo will not allow direct connection to an Apple iPod. However, there are several aftermarket interface adaptor that will allow you to do so: 1. Connect the iPod to a JVC KS-PD100 which in turn is connected to the CD changer jack of the KD-G720 (rear of the unit). Set the stereo to CD changer external input setting and you're ready to go; 2. Connect the iPod to an FM Transmitter such as the Griffin iTrip (w/ Dock connector) which in turn will broadcast the IPod music as an FM signal. Operating the KD-G720 on FM radio setting will receive the IPod's broadcast music. Hope this be of some help to you. Pls post again how things turn up. Good luck and kind regards.