Kyocera mita copier (printhead repearing ((led))

c4000 polygon motor sychronize error, try to cleaning polygon, if not effective, need to replace new polygon.

printer is working but scanner is not working

The problem is with interface cable. Remove the cable and connect it again. Change the ports while connecting the cable and try to print the document. If this does not work, please visit kyocera mita site and contact the dealer for rectification.
Webmaster
www.incomeinnet.com
(An online encycopedia on earning money through internet legally)

The link below will take you to the manufacture's website where you can download all the user manuals for this machine and in them you will find the instructions. If you need further help go to www.gfbm.net


http://usa.kyoceramita.com/americas/jsp/Kyocera/download_center.jsp?pid=13314&pcat=10564&rcid=10009&rscid=10028

your best bet with this one.. is to call kyocera support... they might give you a simple answer.. where as a tech will charge you an arm and a leg...

I’m happy to assist further over the phone at https://www.6ya.com/expert/norman_d2fa496dce30c65d

Format the harddrive, or go to the properties and change the setting that says leave copy on the harddrive, if all this not working try to initialize the memory and you will be fine.
double check on the driver properties check if it says direct printing or it keeps any copy on the machine.

Regards

I’m happy to help further over the phone at https://www.6ya.com/expert/mustafa_06f84c65ab5cc745

Your drum unit is not seated correctly. Look inside for a bent drum ground clip.

when you send a print job it delivere prints without pressing any button. just try it.

Hi,

A downloadable copy of the Kyocera Mita FS-1010 user manual is available here.

Good luck and kind regards.

Thank you for using FIXYA.

on a ricoh - that would be the pcm - photoconductor module on an ecosys the module should last 100,000 pages nothing ever seems to last that long send an email to http://www.pcandl.com/ or call where you bought it