Washing machine showing error e10 ?? - Zanussi Washing Machines

There is problem with intake water.
Could be: inlet valve, wiring, control board

If in other programs it takes water then I would eliminate the control board and I would suspect that it is a faulty winding of the intake valve or wiring between the control board and the intake valve.

Dado

Thank you for your inquiry, Barbara Constable!
I see that your Electrolux washer is displaying an "E10" error code. "E10" stands for fill time too long you may want to check the hoses to make sure they are not restricted or kinked this could cause slow fill within your washer. If the hoses look to be in good shape then I would suggest it could be a faulty sensor or control panel. You could additionally reset your washer by disconnecting power from it for ten minutes. If you restore power and it continues to flash "E10" I would recommend having a professional out to properly diagnosis your washer. Hopefully this information is helpful. -Matt

1 Beep/E10--Error: Water doesn't enter Cause: Water supply problem, Check kinks and faucets
1 Beep/E10--Error: Water leaks Cause: Water connections loose,household drain clog,oversudsing. Correct problems.
1 Beep/E10--Error: Dispenser drawer is open Cause: Washer will not operate if drawer is open.

E10 means that your cold water is coming in too slow, disconnect the cold water hose and check to see if the screen on your washing machine is clogged. If the screen is clean and the hose has good pressure then you will need to replace the water valve on your machine--- this is the piece that the hoses directly connect to.

Here could find additioan sample guide details: fixed-frigidaire-affinity-washer-gives-e10-error

Hope helps.

first dry ok second dry seems too hot then errors

Hello,
The error code E10 is in relation to low water pressure.Have you checked that the hose at rear is not kinked or check the filters in the ends of the hose.Also make sure when you have hose off check the pressure in the supply.If all that is ok then it could be a faulty solenoid valve.

Hope this helps.

The E10 error code means - not filling water.
The problem could be because of clogged filters on the water inlet line or a malfunction inlet valve.
Also there is still some water inside accumulated so please do check the filter for blockages.To avoid other errors check the outlet valve and the filter as a precaution.
Good luck with the machine.Please do rate my solution.Also do post comments for further help if needed.

Is it a washer-dryer? E10 relates to a fault with the inlet valve.....usually the valve itself going open circuit.

The manual suggests the following for E10 error --- 'The Water tap is not turned on.'
It is a valve fault.It is not taking the water in possibly. It is the green side of the triple valve. Try manual clearing the valve.Else The water inlet valve might need a replacement.
Good luck with the machine.Please do rate my solution.Also do post comments for further help if needed.