How do i pput printer back on line - Brother Office Equipment & Supplies

just click add printer
then add local printer
then creat a new port
then pput IP of ur Konica
next finish
then it ask for driver
just give path for driver folder

Take it back to where th etransmission was pput it and if the millage is very slight, they may help you .

I am sorry but we have no diagrams avail here at fixya. If you wish to download them for a small fee you can do that here.

If you have 3 way calling enabled on your phone simply call the first person when they answer press the call button again dial the second number when they answer press the call button again and then both parties should be on the line and be able to hear you and eachother.

click here
Click on above link and download driver for win 7 then install.
Let me know if you need further assistance.
Thanks for using FixYa.

take out the video card and put it back in and then take out ram and clean it and pput it back in

pput old memory back in if it works then you have a bad memory chip or the wrong kind or not matched up.

try to remove the battery and the memory card first, wait for five minutes and pput back the sim card and the battery but not the memory card, try to open it again..

update us what happen

Below is a generic diagram. If only one mark is present it points upward and in line with the crankshaft center line. If two marks are present they line up with the gasket surface of the cylinder head. The piston should be on TDC and the cam lobes should be pointing downward. Be sure the chain is on the crank sprocket, not wedged between the sprocket and the balance weights. Also be sure that the chain is taught on the front side of the engine. Any slack should be at the back side of the cylinder so the chain tensioner can work properly.
Can I get a “very helpful” rating on this answer?

often tho they seem the same the alingment of the nozzles dont match, so check alingment most printers offer you a programme that will do this for you...