Wires disconnected from power supply need wiring order

Sounds like someone has added some other lights. Fog maybe. Under carriage? You will just need to trace them. Factory wires don't have quick disconnects...

Hello,

hello,

simply mean that your oven have been disconnected from the wire that supply power to the oven

what you need to do now is that trace the wire down to the heater it is silver in colour to locate the disconnected wire from it position and fix it up

please note this all source of power supply must be disconnected from power before you can carry out this function .

Good luck in solving the problem....

Check the contactor for power to the coil. You may have not gotten that contactor wire connected to the input power lead when you re-connected your Timer. Also check for 12VDV on both sides of the contactor. You may have 12VDC in but nothing out which means the contactor is not energizing.
Power for the contactors' coil is supplied either with manual selected or Auto and the timer set times are active.
Yu need to find out why the contactor is not being powered. In your case I just think it is a missing wire connection due to the fact that it was fine before you moved it.

Thanks for choosing FixYa,

Kelly

hello,

simply mean that your oven have been disconnected from the wire that supply power to the oven

what you need to do now is that trace the wire down to the heater it is silver in colour to locate the disconnected wire from it position and fix it up

please note this all source of power supply must be disconnected from power before you can carry out this function .

Good luck and thanks for using fixya.

Same color to same color.

On this particular vehicle the blower is supplied power all of the time. The hvac control head supplies the power to the blower resistor to operate the blower. If the wire is actually broken, you need to repair it, or obtain a manual from a local parts store to track it, If the wiring looks ok you will more than likely need to replace the control head in the dash which would be least expensive and easily obtainable at a junkyard.

You need to ground pin 14 momentarily to turn the power supply on. Pin 10 provides +12v, pin 12 provides -12v. Diagram here.

Hi
I bought AKAI LCT3785TA power supply board chipper price $100.00 in ebay:
AKAI LCT3785TA POWER SUPPLY BOARD MLT386X
OR you can order by phone:
213 627 4071
Thanks
DS

disconnect CDROM,DVDROM or any player for that matter and of course any other peripheral attached so as you remain with only monitor ,mother-board,hard disk connected to the power supply.if it doesn't work repair the faulty supply.

disconnect the both the power supply wires from the mb ,
then short out the yellow and purple wires with tweezers or paper clip and watch the fan does it turn for a few seconds , if so the power supply is **t shutting down and is very likely ok.

If you need a supply with those conectors I have one for 5.00 and shipping ,I take paypal.
send me a tech buddy request on this forum for email.
I''v seen the pi**uts somewhere but that was many years ago and **body uses that supply much anymore.
I have ** idea what it cost to send a suppy to you.
those adapters came out late in the product life.