I need 1 leg of a stand for a Philips BDL 4231 TV. One of our legs snapped when moving the tv and we don't want to wall mount it. \r\nThanks, AOM

Before investing time to fix the stand or purchasing another make sure the TV screen is ok, generally they break if the set is knocked over

Hello, Trudy -

Am I correct in thinking you asked this question earlier? [Quote]
My granddaughter has one of your tvs which was mounted on wall now she needs legs hooked on and we can't find screws to fit it was 2015 buy and a 42 inch help [End quote]

If so, it may be more helpful to you if you contact the manufacturer of the TV (contact their Customer Service department, via telephone, so you can speak with a real person.)

I am thinking the TV originally came with a wall mounting and leg attachment kit and you don't have that.

If the TV manufacturer Customer Service cannot help you, I suggest you contact a TV repair business in your area and ask someone there for suggestions regarding mounting the TV on legs.

Best wishes.

1. Unplug all of the cables and cords from your GV42L FHDTV10A.
2. Place the GV42L FHDTV10A face down on a soft and flat surface (blanket, foam, cloth, etc) to prevent any damage to the TV.
3. Pull the stand cover off by squeezing the sides to release the retaining plastic tabs.
(This is probably the trickiest part to find this, just feel around and don't be too rough with the plastic)
4. Remove the four (4) screws (screw's specs: M4, 0.7 Pitch, 15mm long) so that the stand base can be removed.
5. Gently remove the stand base
6. Now, the GV42L FHDTV10A can fit securely to a mount (sold separately) by utilizing the mounting holes in the center of the back panel of the TV. Please make sure to read the instructions of your specific mount to properly hang the GV42L FHDTV10A

Hi, there are two screws underneath the legs of the stand and one other screw to hold the attachment that the legs connect to. If you have removed all three screws then try swiveling the legs.

Hi,

Firstly, before you unscrew anything, lay the screen face down on a mat on a table/desk with the stand hanging off the edge of the table. This will ensure nothing moves without you wanting it to.

There's four screws to remove, two from each leg. Two of them are above where the mains plug goes in, and two above the computer display input socket. Stand should slide out once these have been removed.

assuming it is an infra-red sensor with 3 legs, or 3 legs and 2 other legs as stands, you should be able to use any old 3 leg IR sensor.

If it s a 2 leg one, any other generic 2 leg IR recieve diode will do. With either type, you just need to get the device back in with the same leg configuration. it is usually marked on the circuit board

Did you ever find the legs/table stand for this TV? I'm looking for the same.

It depends how the stand is attached to the TV, model number? Try downloading manual from www.tv.manualsonline.com

on the back you will see either four or six phillips head screws that go through the set and into the legs. unscrew them all and the tv will separate from the legs.

if you have the manual, it will show you exactly where the screws are located

If you are using the stock leg's.

I have the same model, there are 4 knobs on the back of the unit that get inserted into the legs. BE CAREFUL... the unit is heavy, All you have to do is raise one end of the unit up about 1 1/2" and pull towards you a little. You may have to fudge with it a little until it comes out of the leg, but that should be all you need to do.