Sc-486 on the Ricoh Aficio CL3000 printer - Ricoh Aficio CL3000 Laser Printer

Yes it's compatible with windows 7.
Click here
You can download the driver from above link.
Let me know if you need further assistance.
Thanks for using FixYa.

If you mean JOB RESET then there is a button near the printer display. If you want to reset some PM call (for PCU or maintenance kit) you must enter the service mode(hold the two UP and DOWN arrows together for about 6 sec and then released it and press ENTER immediately). You will enter service mode . Choose 2. Engine and press ENTER. theh search for 7. DATA LOG and press enter. Then search for SP7804 PM_COUNT_CLEAR and then press enter. There you can reset what you want. Then press escape to main menu and exit
good luck
pifonski

Did you just replace your color PCUs (photoconductor units)? If so, one of the new units may be defective. Try reinstalling the old units to see if the problem goes away (after resetting the machine). If it does, you can replace the PCUs one by one to see which one is bad.

If you still get the sc441 even with the old PCUs (or if you don't have them anymore) install a set of new PCUs and that should fix the problem. On the off chance the problem doesn't go away even with new PCUs, contact your local service company because you may have a bad circuit board, motor, or gear.

go to the control panel, select printers and double check if the Ricoh Aficio CL3000 Laser Printer was selected as a default printer. you can check it by right clicking the printer name and choose set as default.

Are you using the Mac Drivers from the CD?
Try new Drivers from Ricoh-usa.com.
If its Snow Leopard, go to Apples site and DL there if available.

it is the problem your cartridge sensor chip.You change cartridge unite & buy new cartridge than solve it

SC411: Separation bias error
-Definition- [B] A separation bias leak signal is detected. - Possible causes - · High voltage supply board defective · Poor connection of the PCU · Discharge brush defective You need the service manual or have a technician fix it. If I could be of further assistance, let me know. If this helps or solves the issue, please rate it.
Thanks, Joe


I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

Sometimes it seems to be that the sensor for the waste toner is picking up that it is full. If you clear the are that the the laser reads, many times this error code goes away. Also,, just replacing the waste toner cartridge fixes it.

try to unplug it from the wall and plug it back in and let me know if this works

Este error is critico.
Aqui se encuentra el guia en Ingles:
http://www.ricoh-usa.com/downloads/downloads.asp?tsn=Ricoh-USA&path=http://support.ricoh.com/bb_v1oi/html/oi/rc2/model/cl3500/cl3500en.htm

Impressadoras Ricoh de Puerto Rico:

http://www.ricoh-usa.com/downloads/downloads.asp?tsn=Ricoh-USA&path=http://support.ricoh.com/bb_v1oi/html/oi/rc2/model/cl3500/cl3500en.htm

Please remember to rate all users who assist you for free :) Jose Diaz

I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309