Hi I have a Whirlpool 10KG washer HDW1011W9. F 33 is flashing.Please can you help?

F0d mean slow drain check your pump an drain hose for lint clog up

hi there a diagnostic test you can do look on youtube thanks

shaun

Check this attached link, it may give you incite on your washer problem

Hi from retired Englishman in SW France,

Whirlpool (Kenmore) 'F06' states 'tachometer failure, no motor movement detected'.
Sorry but this requires a service engineer's attention I suggest ;-0(

If this has assisted and/or clarified the situation for you please consider a 4 thumbs up on our rating.
Thanks and good luck!
John C

Hi there,

Water not coming inside solutions:

1. Make sure the inlet has water or the faucet going into the washing machine inlet has free flowing water.

2. Did you turn on the machine on?. This is required specially for heavy duty 10kg Whirlpool industrial grade washing machines..

3. If the two above didnt work. Try rotating the knob to NORMAL and pull it.

4. Contact the nearest Whirlpool service center for repair if problem persists.

Hope this helps

levibit

Hi

Error OL means overload. oL flashes when the machine/motor control detects a load size that exceeds the washer's capacity. To clear the error open the door lid and restart the cycle by removing excess laundry. If error doesn't clears then unplug the washer for 5-10 minutes and check. Hope this helps... Please post back if you need more information.

Daniel

Hi

Ld error indicates long drain and flashes when the water level will not change even after the drain pump is on. To resolve this please make sure that the drain hose is not clogged and the pump is working. To gain access to the drain pump you can lay the machine on its front then remove the drain hose and replace the pump if the impeller has gone bad. Please post a comment if need more help.

Thanks

Rylee

my whirlpool 6th sense dreamspace has a red ligth lit indicating water tap closed can anyone explain why?