I have a Chamberlain CLK1 on my Stanley Drive that quit working, but I can still operate the door with the single push button inside the garage. Is there a remote controlled unit with keypad and remote button available to replace the single push button, similar to what
"Skylink" advertises?
I do not want to replace the CLK1 and then find out that the receiver
in the Stanley Drive is bad!
Re: I have a Chamberlain CLK1 on my Stanley Drive that...
You can use a universal garage remote control kit, you get a new receiver and remote and it is possible to add a wireless keypad.
Universal Garage Remote Control
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
If the wall button will operate the door up but none of the devices do then look at the wall button. Find the lock button and push it for 2 seconds and then try the remotes again. This is your vacation lock. You can get a manual at chamberlain.com. Now if the door does not open or close with the remotes you can reprogram them. Press the colored learn button on the motor head and then press the button on the remote. Repeat for each remote. If they fail to program you will need a new logic board. Thanks BB
You may look at the safety sensors. Try holding the wall button down. If the door operates with the button held down then it is the sensors. Try to align them to look at each other. If not you are probably looking at either replacing the sensors or the logic board. Thanks BB
The inside button is hard wired. The keypad is a small radio transmitter. If the battery in the keypad is good and it doesn't work when you put in the code it has probably just quit.
×