Kyocera Printer FS2000-D says "install

you can reset the counter but on the falcon engines if you go past the maint. cycle they will eventually fall down and print solid black copies.

so,when it tells you to call service,what did you do???

Check where the waste toner bottle is, and if it's like the FS2000, the drum unit can be pushed back in from where the bottle attaches to it.

Error should then go when you close the lid back down

It is telling you that it needs a Maintenance Kit fitted.These are fitted every 500,000 A4 pages.

MK is the maintenance kit. You can check the Kyocera site to find out where to get a new kit and how much they are:

http://usa.kyoceramita.com/americas/jsp/Kyocera/products_printers_details.jsp?pid=12331

Most of the time the message is just displayed because the machine has reached a certain number of pages, but it should still let you use it normally.

install MK means replace the maintains kit . maintains kit is belongs to drum ,developer , drive gears ..... after 250000 print it asking to replace all the things ....... this is not harmful the printer it will work fine don't worry about the install mk....

You have done more than 300,000 pages. I wouldnt waste your money on a Maint Kit, just stretch it out by doing the following.

Press Menu/Ok (Main menu)
Go into [>>Service]
Then press the right arrow.
Then find [>> Maintenance]
Press the ok key, then it will show [>> Maintenance?]
Press the ok key twice, and it will reset all the counts on your consumable components (Drum, Developer, Transfer Roller, ETC)

it needs a maintenance kit... call kyocera support to see which one is required...

I’m happy to assist further over the phone at https://www.6ya.com/expert/norman_d2fa496dce30c65d

The drum is not pushed fully into the machine.Open the waste toner container door and gently push all units into the printer.Then turn off the printer at the wall.When you power back up the printer should be back to normal.

Go to the Start menu and select "printers & Faxes". Ensure that the FS2000 is set as your default printer (right click on icon and select as default). If you still cannot print you will need to reinstall the printer drivers from disk or download from the Kyocera website.