During wash or rinse cyle, water leaks from the bottom

replace drain hose

Either or Both of the below may be the reason:

(1) Sensors have stopped working.
(2) Something is obstructing Drain System.

Call Customer Service Engineer.

tilt dw back

did you check your inner door seal.If it is leaking will appear to be leaking everywhere

sjjordan96,hey just had the repair guy come today. The problem is the one way valve on the washer was clogged. Its easy to get to just remove the bottom panel of the washer and disconnect the drain hose and clear the clog.

Hello,

It sounds like you have some buildup in the cold water valve screen. Where the hose connects to the washer there should be a screen inside the valve. Remove the cold water hose from the washer and clear any debri on the valve screen.

If this doesn't fix the slow cold water flow then you will have to replace the whole water valve assembly. The water valve is the piece that the hoses connect too and supply water to the washer.

If you have anymore questions about this please ask. I will be more than happy to help you out.

Thanks

Since I haven't heard back on this in over a week, I will assume it's been resolved with the clarification questions.

Disconnect power to machine,
Drain all the water you can.
Remove the bottom access panel ( 3 screws on bottom plate)
open the large plastic filter in center
have a tray and towels to catch the water,
remove all clogging material,
look in with a light and turn the pump , it should turn freely.

Plug off the wall. Open the back of the machine to take a good look at the tube coming out from the bottom of the tub, open the front door to see if the door washer is loose somewhere. You could even try to reach out thru the back to locate any loose rubber gasket, the door gasket that is...... Possible you could take out the top of the machine to see if any of the normal 3 tubes entering your dispenser has come loose.....