Problem with printer all buttons flashing

switch off you printer. pull out power cord from source, wait for 5 minutes then plug in back the power cord to the source and switch back ON your printer

Please try to switch to another usb port or try using a different usb cable. try to unplug and replug the cable and check if the computer was able to detect the printer.

For further assistance please contact Lexmark Technical Support

Try to disconnect all cables from the printer and leave it off for about 30 seconds to clear the print job. Turn the printer back on and check the status lights, error light stop blinking then try connecting the printer back to the computer and try printing again.

For further assitance, please contact Lexmark Technical Support

Hello you can try the following, try resetting the printer doing the following. Turn the printer off, then press and hold the arrow pointing left, the select button and the go (green) button. Hold down those three buttons at the same time and power the printer back on and wait if you see a message saying Restoring Factory Defaults. When that message appears you can let go the three buttons. If the same problem of the black boxes that flash appears then you might have a problem either with the Operator Panel or Engine Board. About the price that will run you to replace this parts I don't know.

Please install again the software and get it here : www.nodevice.com/driver/company/Lexmark/Printer.html
www.lexmark.com/
www.driverslab.com/drivers/Printer/Lexmark/9/63.html

Regards. JJY

Sounds like your photocoductor is at lifes end. You can reset it by doing the following
1. Turn the printer off.
2. open the front cover
3. hold down the cancel X button while turning on the power and keep holding down until all lights stop flashing. Then let go of the x button and all lights should start to flash, close the front cover...and it should reset. You may have to turn the printer off and then back on once to be sure it is reset.

open the start menu go to printers and faxes open that find your printer model clear all unprinted jobs then make sure that the printer option is online and ready see if that works for you

good luck

Check pages 76-80

hello!

You will see 3 led lights on the printer. They will blink continously if:

if the print cartridge status light is flashing
-- check if the top cover is open, Close the top cover.
-- there may be a problem with a print cartridge
1. Verify that the correct print cartridges are installed.
2. Check if a print cartridge is low on ink or improperly installed.

if the resume light is flashing
-- the printer may be out of paper
1. Place paper in the In tray.
2. Press the Resume button on the front of
-- the printer may be ready to print the second side of a two-sided document
1. Follow the onscreen instructions for printing the second side.
2. Press the Resume button.

if the power light is flashing
-- the printer is preparing to print
-- The light stops flashing when the printer has received all data.

if all lights are flashing
-- the printer may need to be restarted
1. Press the Power button to turn off the printer, then press the Power button
to restart the printer.Proceed to step 2 if the lights continue to flash.
2. Press the Power button to turn off the printer.
3. Disconnect the printer from the power source.
4. Reconnect the printer to the power source.Press the Power button to turn on the printer.

More or less your printer fuser has gone bad. Replace the fuse. I suggest that when buying a printer you don't with dell 1710N these printers gives a lot a problem. I work with them every day at work.

I suggest that you go with HP.