I have a GE top load washer Model WJRR417G1WW did not spin out after rinse cycle.. any idea? Jen

Sounds like a lid switch

If the fill has a spring then I would suggest you replace the spring.

1) 1st check the filter under the machine (it unscrews behind the access panel 2) open front door and pull back the rubber membrane to see metal and clean out the debris blocking drain holes 3) remove the drain hose from the machine (spring clip) and try and run water thru it and keep blowing out the junk and re-attach 4) run the machine thru 2 cleaning cycles w/bleach and without bleach 5) start using less detergent

timer is bad

Check to load size selector switch, sounds like tube came off of it. The tube goes from switch to bottom of tube, tells machine what size load and when to turn off water.

Check the cold water hose. My brand new machine had this behavior until I discovered a kink in the cold water hose - works great now.

Tell me more Is there voltage to motor? The transmission makes it agitate .

sounds like a bad lid switch how old is it?

Actually, I think I do remember having one do this before, and I believe on these GE models the spin cycle goes through the water level switch, so if your water level switch is sticking, then it won't spin, thinking its still full of water.

Here's the water level pressure switch for your model:
Manufacturer part#WH12X10065 is RepairClinic item#2205


don't forget to rate me in main page,it is the only way i get paid for my works..

DO YOU MEAN THE SPIN RINSE CYCLE OR FILL UP?THE FRONT COMES OFF FROM UNDER THE TOP SEAM,USE A PUTTY KNIFE ON EACH OF THE FRONT SIDES,PUSH IN ON THE CLIP AND PULL OUT ON THE FRONT PANEL,DO THIS ON BOTH FRONT SIDES,LET ME KNOW,THANKS-MIKE