I neid go know how to reprogram one of the controls for the tv in a room but i lost the control for the tv in my living room, in the living room i have the cable box.

Jc4lifes3as

I have provided instructions on how you can program your remote to your TV. Without knowing the brand TV you have, I have provided a link with the codes you can try.

Program to TV:

Remotes: Basic (Television Only)
1. Turn the Television On.
2. Press and hold the TV Power button for three seconds until the LED flashes.
3. Enter the three-digit code using the buttons on the number pad.
4. Press OK. Note: The LED will flash three times.
5. Test functionality with the TV.
6. Return to Step 2 if the remote is not able to turn the TV On/Off, change the volume and mute the television.

Power Scan:

Remote: Basic Remote (Television Only)
1. Turn the Television On.
2. Press and hold the TV Power button for three seconds until the LED flashes.
3. Press and release the TV Power button.
4. Press and release the Up or Down Arrow on the remote until the television turns off.
5. After the television turns off, press and release the OK button.
6. Test functionality with the TV.
7. Return to Step 2 if the remote is not able to turn the TV On/Off, change the volume and mute the television.

The link for the remote codes are at the bottom of the page. Select your receiver type and then your TV brand to get the codes.

http://www.dishnetwork.com/SupportSection/remote-setup

I hope this helps.

Ray Calo
DISH Network"