Developer sign hi Flopez,i have a problem with my sharp ar-5316.I replaced developer but i dont know how to clear the developer.thank you

the door is open

What is the next after f2- or if f2-64 check development un or connect the connector chip.Replace development unit.

hi,
blinking led after replacement of toner cartridge is normal , you have to wait till it gone .
how ever if you feel it take along time then you must check the toner cartridge and reinstall it properly if the machine still blinking you may have to change the developer.

thank you for using fixya

Hallow there, it is always good to understand a specific code and what it means because not all codes are cleared using simulations. Maintenance sign means that the copier needs to be well serviced and checked if something is to be replaced. Consumables such as drum, blade, fuser rollers and developer are changed at such times. If you are sure that you have replaced the correct part or nothing is to be replaced, then you can proceed to clear the sign.

Follow this procedure to clear maintenance sign; Press #, Interrupt, C, Interrupt. keys in that order. Enter 20 and press copy key then enter 01 and press copy key again then press CA key twice to return to normal mode. Wish you success.

hi the service man means yours copier have complet the pm cycle if u dont want to replace drum and devolper u can clear the pm counter with sim 24-4
thanks

I do not understand What is step by step help?
Focus me clearly.This machine setup code is: # interrupt C interrupt.

CH steady means cover is open. Close either front or right cover well.
CH blinking means developer unit or toner cartridge not installed. Remove and return well and firmly.

After you replace developer, press #, interrupt, c , interrupt keys in that order. Display will go off, press 42 print 01 print for developer reset. Press Interrupt key twice and press 20 print 01 print for serviceman reset. Press CA key .

you take the drum out, then unscrew the developer (it should be a greenish screw), it should slide out, empty the developer out, take bag of new developer shake it up real good... then pour evenly into developer unit, while turning the mag roller... reinstall..

Hi Sorry cant send manual U have to buy like every one else.But here are the codes you require It is service code 24 sub code 04 to reset PM counter and sub code 07 to rest drum sub code 09 to reset print count and sub code 11 to reset developer. Hope this helps