GE Simon Security System - help!!

Open the front cover, enter the installer code and "add" the new phone number in "Option 4" as the Primary phone number. "Option 5" is the secondary phone number location on the Simon 3.

Push down on the tab at the top of the panel and open the front panel (Panel will say enter security code now). Put a slotted screwdriver in the top hole and depress to fold dowm the second door. Battery is inside the plastic case with two screws holding on the lid. The battery is a 6V 1.2AH battery

AlarmProfessor.com

Probably knocked off the clip on the piezo. Open the box and make sure all plugs are plugged into the circuit board.

AlarmProfessor.net

You need to reprogram the sensors into the system.

AlarmProfessor.net

It sound like you are programming the sensors as a 24 hour zone. They need to be either a type 10 (entry exit) or type 11 perimeter.

Alarmprofessor.net

I am sure you already guessed this but it appears someone has changed the default installer code. Using the default installer, dealer, or master codes defeat the purpose of a security system as most criminals know the default codes. The only way I know of to regain control of this panel is to reset it to factory defaults. This does mean that you will have to completely re-progam the system. I would document as much stuff as you can from the display before resetting it. If you don't have a copy of the installation manual I am providing a link below. Hope this helps.

http://www.home-technology-store.com/assets/PDF/GE/Simon-Install.pdf

you will need to get the code from the prev. owner and disarm it. Then you can change it and use it.

My problem started when the electricity went off so now everytime I open the door the siren goes off. I don't have a manual so how can I get this to turn off.

Hi,
You need to get the ''installer code'' from your alarm company in order to go into the programming of your system and do the change...and of course the programming manual, please be advised hat if you make any change to your system and something goes wrong your alarm company could charge you in order to fix the problem. Legally, IF you bought the system, you are entitled to get the installer code, the alarm company can't even think to argue about that!.

Thanks,
Lucus123

You need to use an installer code to add/remove sensors. Depending on what number of digits your alarm code is set for will determine the number for the intaller code. Look in the installer manual for the code. Then follow these steps:

Open the panel.
Key in installer coe
Select Add
Select Sensor/Remote
Activate the sensor you want to add. Some sensors have a button, some have to opened to activate.
Choose sensor name and group. Groups are listed in the manual. Basically, if you want the sensor to arm when the doors arm (such as for a window sensor or door sensor) put it in group 10 or 13. If it's a smoke sensor, group 26; motion detector, group 17 and keyfob, group 01.
Press done when finished and run the test to make sure the system is reading the sensor.