I got a whirl pool cabrio and it makes a noise noise and will not drain

Them washer are what you call high efficiency washers.HE. They only use 1 gallon of water to wash them clothes. You go adding more than a teaspoon of soap and that washer is gonna have a cow. Over a period of time that soap gonna build up so much the washer is gonna just give-up the ghost. If you know you use the correct amount of soap there could be something in them pump.You need to remove the service panel and take a looksee at that tech sheet and see what it say about them light flashing. While you at it you may as well remove that cap and clean out that filter. That might put yall back in business. That tech sheet will be in there by that white box which is the motor control unit. The other stuff that the tech sheet error chart might reveal is located on the topside. Good luck on dat repair mon ami.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

is it making a noise when going around if so something is stuck in the front or back bulk head making a clicking noisy as it is going around for example zipper or button of clothing

This means it is stuck between the spin and rinse cycle and the time piece in the housing unit might need replaced if the knob itself isnt stripped also make sure it is on small or large load..

your agitating belt might be slipping or worn, try holding the switch down with a pencil, and keeping the lid open and see if the agitator is moving or sluggish..good luck.

You need to replace your user interface board. Always order with the correct model number on the unit. This will eliminate you issues

well they refuse to adress your issue under a warr. beacause of age , but im certain that a whirlpool auth. servicer will glady adress your issue. As for the F1 generally relates to a faulety control board. but would want( a serveicer ) to check in more detail before jsut askin you to replace the board