Error 935
Printhead Error - Mirror motor unable to reach operation speed Check cables, look for chafing or damage to ribbon cable at sharp bends around rear cover. Replace printhead or ribbon cable.
Hello,
I have the same problem. I think the problem is the impedance of the cable. Each cable haven't the same impedance (resistance of a cable). The solution is to try with several cables.
I hope it will assist you
SOURCE: optra t610 error 935/933/934
replace printhead - scanner assembly. The scanner motor is not working correctly. Need to remove side covers, back of printer assembly, the top cover. Printhead is below the top cover
SOURCE: 935 service printhead error
Hello. Unfortunately, if that's the case, there's not much you can do about it but have it serviced. Hope I can assist you more with it.
SOURCE: 935 Service Printhead Error
This error indicates that the Printhead ( Laser Scanner ) is defective. Sometimes turning the printer off for a little & then turning it back on, gets rid of the error but it will usually return. The printhead is situated at the top of the printer under the top cover. It will need to be replaced.
SOURCE: 935 service printhead error
hello
check this link out
you will get aal the answers for all the printer issue s
http://www.all-laser.com/cgi-bin/webc.cgi/error_lex.html
let me know if you need any assistance
SOURCE: 935 Service Printhead Error
This means that the printhead is defective. The printhead is the actual laser scanner unit which is under the top cover. It will need to be replaced.
The Mirror Motor of the printhead is unable to reach operating speed. This means you have to replace the printhead.
14,839 views
Usually answered in minutes!
×