Tablet not desolving after quick wash cycle - Bosch Dishwashers

Check and clean both spray arms.
make sure nothing is restricting the movements of the arms. Have you selected the correct programme? Quick wash may not always dissolve tablets, you may need to put the tablet straight into cutlery basket at start of quick wash programme

it could be your water preasure or the water is hard,,,but like with most dish washers the tablets dont desolve all the way,,,you need more of a liquid soap type of a cleaner

John, clean filters, add salt and rince aid and buy a bottle of dishwasher cleaner and run the cycle on the 70degree setting. Good luck!

Hi, I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works like new... However I have also foundthat if the heating element goes bad then that also can mess things up bad...So I would buy new spray arms, and also check out the heating element to makesure it is working... Here is a tip that will help you with the onlinebuying...
Dishwasher SprayArms not Spinning

How to Buy ApplianceParts Online

A bad heating element causes many problems in dishwashers...

Dishwasher Problems The HeatingElement not Working

DishwasherMaintenance DishwasherResidue and Film on Dishes

heatman101

Asker's Testimonial "explanation very clear. will give it a go and see howsimple it was. thanks Ronnie " - ronnieshomes

Same problem here. Try greasing the tablet 'drawer' flap with olive oil.

If no good just put the tablet on the cutlery rack.

is it heating if so check spray arm and filters are clean it is washing i take it.....

are these self desolving tablets with covered in plastic film?  If they are use another brand of tablet, or turn the heat up on your water heater as it is set too low.
Had the same problem  

Dishes not cleaned properly....

1. Check the water temperature. Should be 125 to 140 F.
   
2. Check pump re-circulation., Listen, see if it sounds like it is spraying the water around with enough pressure.
   
3. Check water level when the fill cycle has completed. Should be just under the heating element. If not, possibly need to replace the water inlet valve.
   
4. Check the spray arm and pump cover for splits or leaks.
   
5. Check to make sure dishwasher is draining after each cycle. There should only be a little water in the bottom of the tub.
   

check that the spray arms are turning and that the holes in them are not clogged, if you line them up pointing towards the front let the machine fill then as it starts to wash open the door and you should see the arms slowing down, if they are okay then check the water level which should just lap the filter at the bottom

I put the wrong dishwasher on my last post.