My xerox FaxcentreF116 is displaying a message "printer Error Fuser warming" ant it dose'nt do anything any one can help?

Here is the instructions to reset the fuser maintenance count:

HP Color LaserJet 5500/5550 Maintenance Code Reset Instructions

1. Press the ? button until the display reads "CONFIGURE DEVICE" and press ?.
2. Press the ? button until the display reads "RESETS" and press ?.
3. Press the ? button until the display reads "RESET SUPPLIES" and press ?.
4. Press the ? button until the display reads "FUSER" and press ?

This should reset your printer and clear the error message.

I hope this helps, if so please rate my solution,

BuddyMc

1. Turn the printer off, wait 10 minutes, and then turn the printer on. 2. If the message persists, reseat the fuser. If that does not work, replace the fuser. To check the fuser, turn the printer off and remove the fuser. Measure the resistance between the fuser connectors. If it is not within the proper range, replace the fuser. If there is not continuity between the fuser connectors neutral and hot with the fuser removed, replace the fuser. If the problem is not related to the fuser, replace the engine controller board. http://printertechs.com/tech/error-codes/error-codes-50-59.php
Fuser Ref: http://computer.howstuffworks.com/laser-printer3.htm

Hi,

From the Xerox Phaser 4500 Service Manual (here), the main problems could be one of:

• Warm-up failure - Fuser warm-up not complete within 110 seconds after
• starting.
• Cool-down error - Cool-down process not complete within 200 seconds.
• Low trouble temperature - The fuser temperature drops to the low trouble
• temperature (approximately current control temperature, minus
• approximately 25°C).
• High trouble temperature - The fuser temperature rises to the high trouble
• temperature (approximately current control temperature, plus
• approximately 35°C).
• STS circuit open
• STS failure - The heat rod remains on for at least 10 seconds after warm-
• up has completed

It could be that your fuser needs to be replaced, but as you can see that code relates to a couple of problems, so even replacing the Fuser might not fix the problem.

If it doesn't even do the warm up checks it is likely to be the fuser because the other components such as STS failure and cooldown won't have had a chance to run..

Disassemble fuser unit and inspect thermistor and thermostat for dirt or damges, and heater lamp for damages.

Good luck.

Yes it can be the used fuser. Kind of odd for it to be anything else but the fuser.

An LL43 is a fuser temperature error.
When you first turn on the printer it should display printer warming up and after a little while display the LL43. If the fuser is still cold then you probably blew the thermal fuse and it will need to be replaced.

please your xerox phaser is in fuser light is checked is not courently okthis parts is damaze? then changing the fuser temp and new added.

this error comes from fuser unit u have to change fuser unit

The fuser is not coming to temperature. Probably bad temperature senor on fuser. Replace fuser.

Try this,

Reset Fuser Life

1. Using the control panel buttons scroll to Maintenance, press OK.
   
2. Scroll to Check Others, press OK.
   
3. Scroll to Fuser, press Reset