Canon i950 flashing orange green orange green

change/clean manually the main roller because it observe ink.

Hi there ok this should do it
Start with the printer OFF

1. Hold down RESUME and then hold down POWER
2. Release RESUME
3. Press RESUME twice, then release POWER
4. Let green light blink until printer is done futzing

Select function with RESUME press POWER to execute:
presses - light color - function

Number of presses - light color - function
0 presses - green - Test print (or exit service mode on i960)
1 press - orange - EEPROM info print (plus grid nozzle diagnostic on i950)
2 presses - green - EEPROM initialize
3 presses - orange - Reset waste ink counter

All the Best Pineworks

Issue: Power light (or Alarm and Power lights) alternate(s) between orange and green
Solution: The i950 may require repair

Unfortunately, the issue you describe seems to indicate that your product requires repair service.

Copy and paste the link below to locate an authorized service facility and obtain further instructions.

http://www.usa.canon.com/consumer/controller?act=ServiceLocatorAct&fcategoryid=232&modelid=8719

Try turning it off then on. if that doesnt work then un plug it and plug it back in.

It indicate that your print head may defective probably cause by electrical connection. OK u may try this, unplug the print head and clean the print head electrical contact part and also the printer itself contact part with dry paper and install it back. Make sure the contact part is fix into the holder completely. Hope this help.

YBC (/\)

Hi there you can try this

Start with the printer OFF

1. Hold down RESUME and then hold down POWER
2. Release RESUME
3. Press RESUME twice, then release POWER
4. Let green light blink until printer is done futzing

Select function with RESUME press POWER to execute:
presses - light color - function

Number of presses - light color - function
0 presses - green - Test print (or exit service mode on i960)
1 press - orange - EEPROM info print (plus grid nozzle diagnostic on i950)
2 presses - green - EEPROM initialize
3 presses - orange - Reset waste ink counter


All The Best Pineworks

Starting with printer in off condition holding reume and then power respectively,now press resume twice and and release power button le green light blink until printhead has finished moving
now is the most crucial information that has to be followed

0 presses - green light - Test Print
1 press - orange light - EEPROM info print
2 presses - green light - EEPROM initialise
3 presses - orange light - reset waste ink counter.

Thanks And Regards

try unplugging it for about a half hour and then plugging it back in and let me know if this works if no we will figure t what else it could be

For Canon i850, i950, S600
Start with the printer OFF
1. Hold down RESUME and then hold down POWER
2. release RESUME
3. press RESUME twice, then release POWER
4. Let green light blink until printer is done futzing
Select function with RESUME press POWER to execute:
presses - light color - function
Number of presses - light color - function
0 presses - green - Test print (or exit service mode on i960)
1 press - orange - EEPROM info print (plus grid nozzle diagnostic on i960)
2 presses - green - EEPROM initialize
3 presses - orange - Reset waste ink counter

is this still a current issue?